KINGSTON Soap Dish Holder Installation Instructions
Tools Required
- [Phillips Screwdriver]
- [Flathead Screwdriver]
- [Pencil]
- [Hammer]
- [Power Drill]
Parts
| Part | Quantity |
|---|---|
| Mounting Plate | 1 Pc |
| Mounting Screw & Anchor | 2 Pcs |
| Slotted Set Screw | 1 Pc |
Installation Steps
Step 1: Locate where you would like to install the soap dish holder. Place a base onto the wall and trace around it with a pencil (Fig. 1).
Figure 1: Illustrates positioning the soap dish holder base against the wall and tracing its outline with a pencil.
Step 2: Place the mounting plate in the center of the pencil outline you just made and mark the location of the mounting screws (Fig. 2). Drill holes at the marked locations (Fig. 3).
Figure 2: Shows placing the mounting plate onto the traced outline and marking screw positions.
Figure 3: Depicts drilling holes at the marked screw locations.
Step 3: Insert anchors into the holes with a hammer until flush with the wall (Fig. 4).
Figure 4: Shows inserting wall anchors into the drilled holes until they are flush with the wall.
Step 4: Screw the mounting plate (with the lips facing out) to the wall with the mounting screws (Fig. 5).
Figure 5: Illustrates screwing the mounting plate to the wall using mounting screws.
Step 5: Place the unit, with the small hole in the base underneath, over the mounting plate by tightening the slotted set screw with a flathead screwdriver until the base is tightly fixed (Fig. 6).
Figure 6: Shows attaching the soap dish holder unit to the mounting plate by tightening the set screw.
Cleaning
Clean with a damp cloth only. Avoid using metal or abrasive polishes.
