Resistex Miks LED Lighting Fixture

Options / Accessories

Adjustable Orientation

1. Step 1: Place the accessory ring onto the fixture body.

   Visual: Circular fixture with a separate ring. Arrow shows ring being placed onto fixture.

2. Step 2: Insert the fixture into the ceiling cutout.

   Visual: Fixture with ring attached, being pushed into a hole in the ceiling.

3. Step 3: Rotate the fixture to secure it in place.

   Visual: Fixture in ceiling. Circular arrow indicates rotation for locking.

Low Light

1. Step 1: Remove the diffuser or cover from the fixture.

   Visual: Circular fixture. Arrow shows cover being removed.

2. Step 2: Engage the fixture's internal clips or springs.

   Visual: Fixture with cover removed. Arrows indicate clips or springs being activated.

3. Step 3: Insert the fixture with engaged clips into the ceiling cutout.

   Visual: Fixture with clips ready, being inserted into ceiling.

Montage / Installation

1. Step 1: Prepare the ceiling cutout. Required dimensions are Ø69 mm (+/-1 mm).

   Visual: Templates showing a circle of Ø69 mm and a square for reference.

2. Step 2: Insert the fixture into the prepared ceiling cutout.

   Visual: Fixture being pushed into the ceiling hole.

3. Step 3: Push the fixture upwards. The integrated spring clips will engage and secure the fixture to the ceiling.

   Visual: Fixture in ceiling. Arrows show spring clips pushing upwards to secure.

4. Step 4: Prepare the electrical connections. Feed the power supply wires (Live, Neutral, Earth) into the provided connector.

   Visual: Close-up of a wire connector. Arrows show wires being inserted.

5. Step 5: Open the wire connector by following the indicated action (e.g., lifting a lever or opening a clamp).

   Visual: Wire connector shown in an open state. Curved arrow indicates opening mechanism.

6. Step 6: Insert the stripped ends of the Live (L), Neutral (N), and Earth (E) wires into the corresponding terminals within the connector.

   Visual: Open connector with L, N, and E wires being inserted into their respective slots.

7. Step 7: Ensure correct wiring: Live (L) to Live, Neutral (N) to Neutral, and Earth to Earth.

   Visual: Terminal block diagram showing L, N, and Earth connections.

8. Step 8: Close the wire connector securely. Then, push the fixture fully into the ceiling.

   Visual: Connector closed. Fixture being pushed completely into the ceiling.

9. Step 9: Verify the electrical connections are correct. A proper connection is indicated by a green checkmark (✔️). Incorrect connections are marked with a red cross (❌).

   Visual: Two diagrams comparing correct and incorrect wiring connections.

10. Step 10: The fixture is now fully installed.

    Visual: Final view of the installed lighting fixture in the ceiling.

Safety Notes

• Never work on the luminaire when it is live (under voltage).
• Installation must be performed by a professional installer in compliance with current electrical installation standards and regulations.
• Risk of electrostatic discharges (ESD Norm). Handle with necessary precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemical or abrasive products to clean the fixture.
• Keep these instructions for future dismantling or maintenance work.
• Additional information about Resistex luminaires can be found on the website: www.resistex-sa.com.
• Resistex cannot be held responsible for any misuse of the product.