OttLite® Adjust LED Desk Lamp with USB

Congratulations!

You have purchased the finest in natural lighting technology with your new OttLite® product.

Product Registration Form

Please complete the enclosed Product Registration Form and return it today by mail, or register online by going to: OttLite.com/warranty.

Assembly and Operation Instructions

1. Remove the lamp from packing, placing the lamp body base (A) on a flat, steady surface.
2. Connect the power adapter input (G) into the connector (H) in the rear-bottom of the lamp.
3. Plug the A/C adapter (F) into a standard household 120V AC outlet.

   Note: Only use with the supplied AC adapter to avoid damage or fire.

4. The power switch (B) is a "touch" switch that controls ON/OFF power, the LED brightness settings, and the color mode function of the lamp.
5. To power LED settings, slightly touch the switch (B) to achieve the following:
   • To turn lamp "ON" to 1st brightness setting: touch the switch "once".
   • For 2nd brightness setting: touch the switch "two-times".
   • For 3rd brightness setting: touch the switch "three-times".
   • To turn lamp "OFF": touch the switch "four-times".
6. This lamp provides three color modes. To adjust lighting color mode, touch the switch (B) to turn "ON" the lamp, then slightly touch the switch (B) and keep depressed for 1-2 seconds to change light color temperature mode: 5000K, 4000K, 2700K.

   NOTE: The lamp will remember the last color mode setting.

7. To reposition the light, hold the base (A) steady and grasp either the lamp body (C) or shade (D) depending on needed adjustment.

Safety Warnings

1. Turn lamp off and WAIT UNTIL LAMP HEAD (D) AND ADAPTER (F) ARE COOL before handling.
2. The LED panel (E) might get hot after several hours of continuous use. DO NOT place your hands directly on the LED light panel.
3. Never use with an extension cord unless the plug can be fully inserted into the receptacles in the extension cord.
4. Do not alter the plug.
5. The lamp head included with this unit cannot be replaced by the consumer.
6. INDOOR USE ONLY.

FCC Part 15

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that of the receiver.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

CAN ICES-005 (B)/NMB-005

AC/DC Adapter & USB Port

Input: AC 100-240V, 50/60 Hz, 1A

Output: 24V DC, 1A with a Male DC Plug

This lamp contains a 5V-2.1A USB output port (J) located on the bottom rear of the lamp. The USB port can charge items such as tablets, cellular phones, etc.