Resistex Miks LED Luminaire

Safety Notes

• Never work on the luminaire when it is live (under voltage). ⚡
• Installation must be performed by a professional installer, adhering to all relevant electrical installation standards and regulations.
• Risk of electrostatic discharges (ESD Norm). Handle with necessary precautions.
• Please observe the provided notes and follow the mounting steps carefully.

Maintenance Instructions

• Do not use chemical or abrasive products to clean the luminaire.
• Keep these instructions for future dismantling or maintenance work.
• Additional information about RESISTEX luminaires is available on the website: www.resistex-sa.com
• RESISTEX cannot be held responsible for any misuse of the product.

Installation Steps

Options / Accessories

Adjustable / Orientable

• Step 1: Illustrates a circular fixture with a rotating ring, indicating adjustability.
• Step 2: Shows the fixture being inserted upwards into a mounting bracket.
• Step 3: Depicts the ring being rotated to adjust the fixture's angle.

Low Luminance / Basse Luminance

• Step 1: Shows a fixture with a diffuser or lens.
• Step 2: Depicts clips or springs attached to the fixture.
• Step 3: Shows the fixture being inserted into a mounting bracket, with the springs engaging to secure it.

Montage / Installation

• Step 1: Provides dimensions for the ceiling cutout: Ø69 mm (+/-1 mm). It also shows the fixture itself.
• Step 2: The fixture is shown being pushed upwards into the prepared ceiling opening. ⬆️
• Step 3: The fixture is rotated to secure it in place. ↪️
• Step 4: Illustrates the electrical connection: wires are prepared and inserted into a connection block.
• Step 5: The connection block is shown being closed after the wires are inserted.
• Step 6: Shows the connection block being opened again, with wires correctly inserted into terminals.
• Step 7: A terminal block is depicted with connections for Live (L), Neutral (N). Wires are shown connected to these terminals.
• Step 8: The fixture is shown with its spring clips extended, ready for insertion into the ceiling.
• Step 9: A diagram shows correct electrical connection (checkmark ✔️) with a stable waveform, and incorrect connection (cross ❌) with a distorted or absent waveform.
• Step 10: The final installation shows the Miks luminaire flush with the ceiling surface.