PicoKom Power Supply Unit 24 V - 130 mA, 2 Outputs

Product Description

Domestic 24 V-power supply (130 mA) that powers equipment through the input coaxial cable while allowing the transmission of the TV signal. Included in the installation to power either mast amplifiers or a BOSS system. Furthermore, it is equipped with two outputs.

Packaging Info

Physical Data

Highlights

• High-performance switched-mode power supply: saves up to 40% power consumption
• Very low power consumption
• Pleasing design and ultra-small size: can be installed in 100 mm x 100 mm connection boxes
• EasyF connection system
• Fully automated manufacturing, subject to the most stringent quality controls

Main Features

• Can be wall-mounted using screws
• Through losses may vary depending on whether 1 or 2 outputs are used

Discover EasyF Connection System: Simplicity and Savings

EasyF is an innovative connection concept where the inner conductor of the coaxial cable is directly inserted in the device, thus improving connection reliability. Thanks to the absence of F connectors, the chassis can be reduced and the connection of two cables secured with a single screw.

• Real time savings: Speeding the installation is possible without the need for coaxial cable termination. Furthermore, there is no need for screwing the connectors on the device, which is sometimes difficult when there is little room.
• Connection reliability: The clamp holding the cables prevents the coaxial cable from coming off.
• Cost savings: No additional connectors are required (neither F nor IEC).
• Space optimization: Inputs and outputs are always on the same side of the device to prevent coaxial cables from bending, and to make working inside cabinets and register boxes easier.
• Very easy three-step mounting: Only screwing and unscrewing the covers is required to connect both cables:
  1. Unscrew the device's cover to access the connection.
  2. Insert the previously stripped coaxial cables.
  3. Close the cover and screw to ensure connection.

Learn More About EasyF System Reliability

With EasyF, the connection between the coaxial cable and the device is carried out using an automated system for contact insertion of the inner conductor, without any soldering.

• Always as new: the device's operating life increases when the factor of solder wearing out with time is removed.
• Failure rate reduction: usually produced as a result of cold soldering joints.
• Electromagnetic behaviour optimization: for high frequencies.
• Our commitment with environment is reinforced: pollution caused by the welding process is eliminated and production power consumption is reduced.

Application Example

The diagram illustrates an application example. An antenna is shown at the top, connected to an "Amplifier" unit. From the amplifier, a coaxial cable carries a "Vdc" power signal and the TV signal to the Televes PicoKom power supply unit (model 5795/579401). The power supply unit has two outputs, each connected to a device via coaxial cable, also carrying a "Vdc" signal. Signal strength indicators are shown next to the output devices.

Technical Specifications: Ref. 5795