Televes

Kit: Nanokom Mast Amplifier + PicoKom Power Supply Ref. 561621 + Ref. 5796

Kit Components:

• Ref. 561621: Nanokom Mast Amplifier
  Features 3 inputs: UHF, VHFmix, IFmix. This mast amplifier is used for amplifying and mixing terrestrial and satellite TV signals received from various antennas. The UHF input provides amplification, while the VHF and IF (SAT) signals are mixed. It includes a DC power pass-through towards the satellite input for LNB power supply.
• Ref. 5796: PicoKom Power Supply
  12V - 220mA, with 1 output. This power supply delivers 12V via the coaxial cable, allowing TV signal to pass through. It is used for powering mast amplifiers or the BOSS system. It is compatible with IFmix amplifiers and automatically detects the presence of a signal managed by the LNB (voltage and tone) from the receiver.

Additional Information

Color: Orange

Packaging:

• Blister: 1 unit
• Box: 8 units

Physical Data:

Distinguishing Features

• Equipped with "USOS" (User Selectable Output Signal) technology, allowing the user to select the desired output level, with automatic device adjustment to input signal fluctuations.
• Separate amplification and very low noise figure.
• Ultra-reduced dimensions and ergonomic design.
• EasyF connection system.
• 12V - 24V power supply.
• Fully automated production with rigorous quality control.
• High-shielding, die-cast (zamak) housing.
• LTE700/5G filter to prevent interference from mobile phone bands.
• ON/OFF switch for DC pass-through to the UHF input for powering the BOSS system.
• Easy installation. Includes a cable tie for mast mounting.
• Durable ABS plastic housing for outdoor installation (orange color).

EasyF Connection System - Easy and Quick Installation

EasyF is an innovative connection system for the inner conductor (core) of coaxial cables. The core is inserted directly into the device, thus increasing connection reliability. Furthermore, by eliminating F connectors, device dimensions are reduced, and two cables can be secured with a single screw.

• Time saving: Faster installation, no need to attach connectors to coaxial cables. It also avoids the process of screwing connectors into the device, which is sometimes impossible due to lack of space.
• Reliable connection: A collar that holds the cable prevents it from loosening.
• Cost saving: Installation does not require additional F or IEC connectors.
• Space optimization: Inputs and outputs are on the same side of the device, preventing cable kinking and facilitating installation work.
• Three simple installation steps: connecting two cables requires only unscrewing and screwing the cover:
  1. Unscrew the splitter cover to access the connection.
  2. Insert the pre-prepared coaxial cable.
  3. Close and screw the cover.

Discover the reliability of the EasyF system

With EasyF, coaxial cable connection to the device is performed through an automated system that inserts the cable core into the contact, eliminating the need for soldering.

• Longer device lifespan: Elimination of solder joints extends device lifespan.
• Reduced failure rate: Typically caused by cold solder joints.
• Electromagnetic interference optimization: For high frequencies.
• Strengthening our commitment to environmental protection: No pollution from welding processes and reduced energy consumption in production.

Application Example

The diagram illustrates a typical installation scenario. It shows a terrestrial antenna (UHF/VHF) and a satellite dish connected to the Nanokom mast amplifier (Ref. 561621). The amplifier then outputs signals to a TV and a set-top box (STB). The PicoKom power supply (Ref. 5796) is shown powering the LNB on the satellite dish via the coaxial cable, with an option to switch the STB power ON or OFF.