Included Parts
- Pendant shade x2
- Mounting plate & ceiling rose x1
- Bulb holder & cover, lighting cables, aluminium spacer & (3x) rubber washer x1
- Terminal box x1
- Fastening bolt x1
- Ground screw x1
- Chain x1
- Hex key x1
- Foam washer x1
- Anchor screw x2
- Anchor x2
Tools You'll Need
- Drill [Drill]
- 6mm drill bit [6mm drill bit]
- Crosshead screwdriver [Crosshead screwdriver]
Product Specifications
| Location | Interior |
|---|---|
| Class | Class II |
| IP rating | IP20 |
| Driver required | No |
| Fire rating | No |
| Cable length | 2m |
| Bulb type | LED strip (E27) |
| Max wattage | 12W LED |
| Bulb included | No |
| Switched | No |
| Dimmable | Bulb dependent |
| Rated voltage | 230V-250V |
| Rated frequency | 50-60Hz |
Important Notes:
- Luminaries must be installed by a qualified electrician.
- All luminaries should be installed in dry conditions.
- Turn off electrical supply to circuit before installation.
Installation Instructions
Step 1
Push to remove the 'knockouts' on the mounting plate that best relate to where your mains power cables/ceiling cavity is located.
Step 2
Screw the mounting plate to your ceiling using the anchors provided.
Step 3
Drop the bulb holder through the larger shade. Add the rubber washer (curve face up) before threading the spacer over the top, clamping the pendant shade securely.
Step 4
Add another rubber washer (curve face down) and the brass collar before adding the second, smaller shade.
Step 5
Use the final rubber washer (curve face up) and bulb cover to attach the two shades.
Step 6
Adjust the length of the lighting cable using the grub screw on the end of the cable. Cut chain down if necessary.
Step 7
Hook the now-adjusted cable through the ceiling rose cover and slide into the centre of the pre-mounted plate.
Step 8
Repeat step 5 if the cable length is unsatisfactory, then secure in place with the fastening bolt.
Step 9
Make connections in terminal box provided.
Step 10
Thread the cover over the mounting plate.
Step 11
Add an E27 bulb.
