Kensington Wall Light
Instructions
CORSTON
What's Included
- Wall light fixture x1
- Wall plugs x3
- Screws x3
- M3 hex bolts x3
- Hex key x1
(Diagrams in the original document illustrate these components.)
Specifications
- Location
- Exterior
- Class
- Class II
- IP Rating
- IP44
- Driver Required
- No
- Fire Rating
- No
- Cable Length
- N/A
- Bulb Type
- E27
- Max Wattage
- 12W
- Bulb Included
- No
- Switched
- No
- Dimmable
- Bulb dependent
- Rated Voltage
- 230V-250V
- Rated Frequency
- 50-60Hz
This product must be installed in dry conditions by a qualified electrician. Ensure the electrical supply to the circuit is turned off before installation.
Tools You'll Need
- Drill
- 6mm drill bit
- Clippers or scissors
- Crosshead screwdriver
(Diagrams in the original document illustrate these tools.)
Installation Instructions
Step 1: Prepare Grommet
Remove the grommet to cut off the tip.
(Original diagram shows grommet removal.)
Step 2: Route Wires
Put the grommet back and push the wires through it. Ensure the gasket is in place on the mount base.
(Original diagram shows wires passing through grommet and gasket onto mount base.)
Step 3: Mount Base Ring
Drill three 6mm holes and set the anchors. Use the screws provided to attach the base ring to the wall.
(Original diagram shows drilling, anchors, and base ring attachment.)
Step 4: Electrical Wiring
Consult a qualified electrician to wire in the light.
(Original diagram depicts consulting an electrician.)
Step 5: Attach Light Fixture
Attach the light to the mount base using the screws provided.
(Original diagram shows attaching the light fixture to the mount base.)
Step 6: Secure Brass Ring
Screw the brass ring onto the base.
(Original diagram illustrates screwing the brass ring onto the base.)
Step 7: Install Bulb
Add the bulb.
(Original diagram shows inserting the light bulb.)
Step 8: Fit Glass Cover
Place the glass cover over the top and secure in place with the ring.
(Original diagram depicts fitting the glass cover and securing it.)
