Corston Richmond Pendant Light

Included Parts

• Light body x1: A diagram showing the main part of the pendant light, consisting of a decorative shade suspended by a cable.
• Ceiling mount x1: A diagram illustrating a circular or rectangular mounting plate designed to attach to the ceiling, with holes for screws and a central opening for wires.
• Wall screw x3: A visual representation of three screws suitable for mounting.
• Anchor x3: A visual representation of three wall plugs or anchors, typically used with screws for mounting into plasterboard or masonry.
• 2-terminal WAGO x1: A diagram of a single WAGO connector with two ports for connecting wires.
• 3-terminal WAGO x2: A diagram of two WAGO connectors, each with three ports for connecting wires.
• Hex key x1: A diagram of a single L-shaped tool used for tightening grub screws.

Tools You'll Need

• Crosshead screwdriver: A diagram of a screwdriver with a cross-shaped tip (Phillips head).

Installation Notes

Note: The glass cover protects the bulb in wet environments and is required for the IP rating. If the light is installed in a dry setting, you can remove the glass cover to increase the life expectancy of the bulb.

Installation Steps

1. Step 1: Install the pendant light mount, using wall plugs if needed. Refer to page 3 for dimensions.

   [Diagram: Ceiling mount being fixed to a ceiling surface, with screws and possibly wall plugs being used.]

2. Step 2: Push the wires through the grommet.

   [Diagram: Wires being passed through a circular opening, likely fitted with a rubber grommet, on the ceiling mount.]

3. Step 3: Adjust the cable length using the grub screw.

   [Diagram: A close-up view of the top of the pendant light assembly, highlighting a small screw (grub screw) on the cable entry point.]

4. Step 4: Make the connections in the base using the WAGO connectors provided.

   [Diagram: Electrical connections being made. Wires are shown inserted into WAGO connectors.]

5. Step 5: Tighten the grub screws.

   [Diagram: Similar to Step 3, emphasizing the action of tightening the grub screw to secure the cable.]

6. Step 6: Unscrew the glass cover to fit the bulb.

   [Diagram: Pendant light fixture with the glass shade being unscrewed or removed to allow access for installing a light bulb.]

Dimensions

The ceiling mount plate has the following dimensions:

• All holes 5mm
• Width: 73mm
• Depth: 46mm

Note: For accurate sizing, print this diagram on A4 paper.