Corston Small Wall Light
Installation Instructions
Included Components
- Light body x1
- Wall mount x1
- Wall screw x3
- Anchor x3
- 2-terminal WAGO connector x3
- Hex key x1
Tools You'll Need
- Drill
- 6mm drill bit
- Crosshead screwdriver
Installation Steps
Step 1: Mount the Wall Bracket
Install the wall light mount. Refer to page 4 for dimensions.
Step 2: Route the Wires
Push wires through the grommet.
Step 3: Connect Wiring
Connect the WAGO connectors inside the base of the light fixture.
Step 4: Secure the Light
Tighten the grub screws to secure the light body to the mount.
Step 5: Install the Bulb
Unscrew the glass cover to add the bulb. Note: The glass cover protects the bulb in wet environments and is required for the IP rating. If the light is installed in a dry setting, you can remove the glass cover to increase the life expectancy of the bulb.
Step 6: Attach the Shade
Choose your preferred method:
- Claremont style: Screw the shade directly onto the light body.
- Malvern style: Use the provided shade ring to secure the shade.
- Richmond (hanging) style: Use the grub screw to adjust the shade height.
Wall Mount Dimensions
The wall mount features mounting holes with a 5mm diameter. The overall width of the mount is 59mm. The lower bracket extends 31mm.
