Southwark Mast Light
Brand: Corston Architectural Detail
Included in the Box
- Mast light x1: A conical, upward-facing light fixture.
- Wall plug x2: Cylindrical plastic anchors for wall mounting.
- Screw x2: Standard screws for mounting.
- M4 hex bolt x2: Bolts with hexagonal heads, size M4.
- Hex key x1: An L-shaped metal tool for tightening bolts.
Specifications
| Location | Exterior |
|---|---|
| Class | Class I |
| IP rating | IP56 |
| Driver required | No |
| Fire rating | No |
| Cable length | N/A |
| Bulb type | GU10 |
| Max wattage | 8W |
| Bulb included | No |
| Switched | No |
| Dimmable | Bulb dependent |
| Rated voltage | 230V-250V~ |
| Rated frequency | 50-60Hz |
Important Note: This product must be installed in dry conditions by a qualified electrician. Turn off electrical supply to circuit before installation.
Tools You'll Need
- Drill: A cordless power drill.
- 6mm drill bit: A metal drill bit with a 6mm diameter.
- Clippers or scissors: A pair of cutting shears.
- Crosshead screwdriver: A screwdriver with a Phillips head.
Installation Instructions
Step 1: Prepare the Base
Remove the grommet to cut off the tip.
[Diagram: Rubber grommet being removed from the light fixture base]Step 2: Route the Wires
Replace the grommet in the base and push the wires through it. Important: use insulated cable and make sure the outside layer goes through the grommet.
[Diagram: Electrical wires being fed through the grommet in the light fixture's base]Step 3: Electrical Connection
Consult a qualified electrician to wire in the light.
[Diagram: Electrical connections being made to the light fixture]Step 4: Mount the Base
Drill two 6mm holes and set the anchors. Use these to screw the base to the wall.
[Diagram: Two holes drilled into a wall, anchors inserted, and the light fixture base screwed to the wall]Step 5: Install the Bulb
Insert the bulb into the bulb holder.
[Diagram: GU10 light bulb being inserted into the light fixture's socket]Step 6: Secure the Fixture
Place the bulb under the plate and tighten the two screws as shown.
[Diagram: Light fixture's internal plate positioned and secured with two screws]Step 7: Attach the Shade
Hook the brass shade over the base and make sure it sits flat.
[Diagram: Conical light fixture shade being attached to the base]Step 8: Secure the Cover
Secure the cover in place with the grub screw provided.
[Diagram: Small grub screw used to secure the light fixture's cover]For inquiries: hi@corston.eu | +44 (0)1249 549332
Document Reference: IN-0072-EN-EU_r0
