Momcozy Wearable Breast Pump

Installation Instructions

*Before installation, ensure your hands are clean.

1. Connect the membrane and valve to the connector.

   [Diagram: Shows a breast pump membrane and valve being connected to a connector piece.]

2. Connect the assembled connector to the milk collection cup. Align the connector's "ear" with the groove on the cup.

   [Diagram: Shows the assembled connector being attached to a milk collection cup. A close-up indicates aligning a small protrusion ("ear") on the connector with a groove on the cup.]

3. Attach the flange to the milk collection cup.

   [Diagram: Shows a breast pump flange being attached to a milk collection cup.]

4. Assemble the pump motor unit and milk collection cup.

   [Diagram: Shows the pump motor unit being placed on top of the assembled collection cup and flange, with a downward arrow indicating assembly.]

How to Prevent Milk Leakage and Tips for Pumping More Milk

1. Lean forward to ensure the nipple is centered in the flange tunnel. The pump should be securely positioned against your breast.

   [Diagram: Illustrates correct positioning of the pump on the breast, showing the nipple centered within the flange.]

2. It is recommended to wear a full coverage nursing bra to create a snug seal between the breast and the flange.

   [Diagram: Shows a person wearing a nursing bra with the pump inside, indicating a snug fit.]

3. Ensure the pump is assembled correctly.

4. When pumping, sit or stand upright; do not lie down.

Pouring Milk

When pouring milk, hold the milk collection cup in the correct direction.

[Diagram: Shows hands holding a collection cup to pour milk into a bottle. An incorrect angle is marked with a red cross symbol ❌, and the correct angle is marked with a green checkmark symbol ✔️. The label "Groove" is near the correct pouring image, indicating a specific orientation.]

Cleaning and Sterilization

Non-washable parts:

• Motor unit

Washable parts:

• Milk collection cup
• Flange
• Membrane
• Connector
• Valve

For cleaning washable parts, use soapy water (40-60°C / 104-140°F) for 3-5 minutes. For sterilization, use boiling water / steam / sterilizer container, ensuring the temperature does not exceed 100°C (212°F). Boil and sterilize parts for 5-10 minutes.

*It is not recommended to sterilize breast pump accessories in a microwave oven, as this will shorten their lifespan.

Tips

• The expected lifespan of washable parts is 1-3 months. It is recommended to replace washable parts after long-term storage or before pumping for another child.
• The pump will automatically shut off after 30 minutes of pumping. If irritation or discomfort occurs, discontinue use and consult a doctor.

Troubleshooting

If you encounter any issues during installation or pumping, please refer to troubleshooting videos. Access to these videos is available via QR code scanning.

[Diagram: A QR code is present, typically used to access online resources like troubleshooting videos.]