Momcozy Wearable Breast Pump

Assembly Guide

Important: Ensure your hands are clean before assembly.

1. Connect the membrane and valve to the flange.

   [Diagram: Shows the membrane and valve being attached to the flange.]

2. Connect the assembled flange to the milk collector.

   [Diagram: Shows the assembled flange being attached to the milk collector.]

3. Connect the breast shield to the milk collector.

   Align the "ear" to the slot.

   [Diagram: Shows the breast shield being attached to the milk collector, aligning the "ear" to the slot.]

4. Assemble the pump and milk collector.

   [Diagram: Shows the final assembly of the pump unit and milk collector.]

Pouring Milk

Hold the milk collector in the correct direction when pouring milk.

[Diagram: Two illustrations showing milk pouring. One with a red cross ❌ indicating incorrect angle, and one with a green checkmark ✔️ indicating correct angle, aligned with a groove.] Correct pouring direction is indicated by a groove.

Troubleshooting

See the troubleshooting video for more solutions if any problems arise during assembly or pumping.

Scan the QR code to open the troubleshooting video.

[QR code for troubleshooting video]

How to Avoid Milk Leaks and Pumping Tips for More Breast Milk

1. Lean forward to ensure your nipple is centered in the breast shield tunnel. The breast pump should fit snugly against your breast.
2. We recommend users wear a nursing bra with full coverage to create a tight seal between the breast and the breast shield.
3. Ensure the pump is assembled correctly.
4. Pumping should be done while sitting or standing, not lying down.

Washing and Sterilization

Parts that can be washed:

• Milk Collector
• Breast Shield
• Membrane
• Flange Connector
• Valve

Parts that cannot be washed:

• Pump Motor

Washing Instructions:

We recommend using soapy water (40-60 °C) to clean washable parts for 3-5 minutes.

Sterilization Instructions:

Use boiling water, steam, or a sterilizer with a temperature not exceeding 100 °C (212 °F). Boil and sterilize parts for 5-10 minutes.

Note: It is not recommended to sterilize the breast pump in a microwave, as this will shorten the lifespan of the accessories.

Tips

• The expected lifespan of washable parts is 1-3 months. It is recommended to replace washable parts after long-term storage or before using the pump for your next child.
• The breast pump automatically shuts off after 30 minutes of pumping. Discontinue use if irritation or discomfort occurs and seek help from a healthcare professional.