MAULsenja 825 88 LED Floor Lamp

BOKE Constant Voltage LED Driver

Model: BK-HGV100-48V0

Input: 200-240V~0.8A Max. 50/60Hz, λ:0.95

Output: 48V 2A 96W Max.

Certifications: CE, UKCA, TÜV, Flicker Free, SELV.

This component is a power supply for the LED modules. It is supplied with two cable ties.

Visual Description: A rectangular electronic device with input and output terminals. It bears various safety and certification marks.

Keysolu Constant Voltage LED Driver

Model: KS4 5-24Z2-M

Article No.: 8258809.211

Visual Description: Another type of LED driver board, compact in size, with input and output connection points.

LED Strips and Modules

Article No.: 8258809.205 (LED Strip)

Article No.: 8258809.200 (LED Strip)

Article No.: 8258809.225 (LED Module)

Visual Description: These are long, flat circuit boards populated with multiple LEDs, designed to emit light.

Step 1: Base Attachment

Visual Description: The base of the floor lamp is shown with rubber feet. Screws are circled, indicating attachment points for securing the lamp's upright structure. An Allen key is also shown.

Action: Secure the lamp structure to the base using screws.

Step 2: Component Connection (Sliding)

Visual Description: Two sections of the lamp's frame are shown. An arrow labeled "ZIEHEN PULL" indicates that one section should be pulled to connect or slide into the other.

Action: Slide components together by pulling.

Step 3: Connector Manipulation

Visual Description: Close-up views of electrical connectors. Arrows point to specific parts of the connectors, labeled "DRÜCKEN PUSH a)" and "ZIEHEN PULL b)".

Action: To connect or disconnect, first press a specific point on the connector ("PUSH a)"), then pull the cable or connector ("PULL b)").

Step 4: LED Driver Screw Adjustment

Visual Description: A close-up of the LED driver showing two screws securing it. Text indicates "Loosen the 2 screws!! Do not unscrew completely!!". A PH2 screwdriver is shown.

Action: Loosen the two retaining screws on the LED driver, but do not remove them entirely.

Step 5: Wire Connection

Visual Description: Close-up of the LED driver's output terminals. Wires are shown being connected to screw terminals labeled V+, V-, etc.

Action: Connect the wires from the LED components to the corresponding terminals on the LED driver.

Step 6: Driver Removal

Visual Description: An image showing the LED driver assembly. An arrow labeled "ZIEHEN PULL" indicates the direction to pull the driver to detach it from its mounting or connection.

Action: Pull the LED driver to remove it.

Step 7: LED Strip Removal

Visual Description: The main lamp body is shown disassembled, revealing the LED strip. Multiple screws are circled, indicating they hold the LED strip in place. A PH2 screwdriver is shown. An arrow labeled "RAUS ZIEHEN PULL OUT" points to the connector for the LED strip.

Action: Remove the screws securing the LED strip. Then, pull the connector to detach the LED strip.

Step 8: Securing LED Modules/Strips

Visual Description: A close-up of the lamp housing showing an LED strip or module being secured. A screw is shown being inserted or tightened with an Allen key (1.5mm indicated).

Action: Secure LED modules or strips using screws.

Step 9: Final Connection

Visual Description: A close-up of the LED module connector. An arrow labeled "ZIEHEN PULL" indicates the action to connect or disconnect the module.

Action: Connect or disconnect the LED module by pulling the connector.