How to Avoid Milk Leaks and Tips for Obtaining More Breast Milk During Extraction
- Ensure the breast pump is assembled correctly.
- Lean forward to ensure the flange is properly positioned against the breast, creating a seal. [Diagram: Person leaning forward, positioning the flange against the breast.]
- Wear a nursing bra to support the breast and flange. [Diagram: Person wearing a nursing bra, showing support for the breast and flange.]
- Lean slightly forward to remove the breast pump from the breast after pumping.
Tips
- Washable parts have an expected lifespan of 1-3 months. Replace them after prolonged storage or before pumping for a new pregnancy.
- The breast pump automatically shuts off after 30 minutes of use.
- If you experience discomfort or pain, or if there is a gap between your breast and the flange, stop use and consult a doctor. [Diagram: Finger shown between breast and flange, indicating a potential gap.]
For inquiries, please contact support@momcozy.com.
Assembly Instructions
Refer to the user manual for more information.
*Ensure your hands are clean before assembly.
- Align the milk collector with the flange, ensuring all parts connect tightly. [Diagram: Aligning the milk collector and flange.]
- Hold the breast milk collector correctly to direct milk flow. [Diagram: Correct orientation of the milk collector.] Gently insert the valve into the collector, ensuring no gaps. [Diagram: Inserting the valve into the collector.]
Connect the long end of the tubing to the breast pump motor.
For greater convenience, scan the QR code above to access the operation guide video for more solutions.
Cleaning and Sterilization
Non-washable Parts:
- Tubing
- Breast Pump Motor
Washable Parts:
- Milk Collector
- Flange
- Valve
Cleaning and Sterilization of Washable Parts:
- Wash with soapy water (40-60°C / 104-140°F) for 3-5 minutes.
- Sterilize using steam or a sterilizing container at 100°C (212°F) for 5-10 minutes. [Diagram: Steam sterilization of pump parts.]
Warning: Do not sterilize pump parts in a microwave or UV sterilizer, as high temperatures can reduce their lifespan and pose safety risks. [Diagram: Crossed-out microwave and UV sterilizer symbols.]
Control Panel
Indicators:
- Suction Level Indicator
- Working Time / Suction Level Indicator
- Mode Indicator
- Battery Display
Buttons:
- Power On / Off (Press and hold)
- Decrease
- Increase
- Mode Selection
Operation:
- Press and hold to turn on/off.
- Briefly press to pause/resume pumping session.
Modes: Stimulation, Expression, Mixed.
