MAL 7157 Light Fixture Installation Guide

Installation Steps

Step 1: Mount the Bracket

Securely attach the mounting bracket to the ceiling using appropriate screws.

Step 2: Connect Wires

Connect the electrical wires from the fixture to the corresponding wires in the ceiling junction box. Ensure connections are secure.

Step 3: Wire Connections Detail

Identify and connect the terminals: L (Phase), N (Neutral), and G ([Earthed Conductor Symbol]) to the respective supply wires.

Step 4: Attach Fixture Body

Carefully attach the main body of the light fixture to the previously mounted ceiling bracket.

Step 5: Secure the Fixture

Fasten the fixture to the bracket using the provided screws or locking mechanisms to ensure it is firmly in place.

Step 6: Final Assembly

Complete the installation by attaching any final covers or diffusers as required.

Safety Instructions

1. Installation must be performed only by authorized and qualified technicians according to current electrical installation regulations.
2. The manufacturer is not responsible for injuries or damages resulting from improper use of the light.
3. Maintenance is limited to cleaning the surfaces. For electrical safety, do not clean with water or other liquids; use only a dry, lint-free cloth.
4. [Caution Symbol] Risk of electric shock. Check the entire light for damage before connecting to the mains. Never use if damaged.
5. [Attention Symbol] Disconnect the mains cable from the power supply before assembly or disassembly. Switch off circuit breakers or remove fuses. Ensure all switches are OFF.
6. [Attention Symbol] Before drilling mounting holes, ensure no gas, water, or electricity pipes/wires can be drilled through or damaged at the location.
7. Ensure mounting material is suitable for the subsurface and that the subsurface can bear the weight of the fixture. The manufacturer is not liable for improper installation.
8. [Recycling Symbol] The symbol of a crossed-out garbage can means this product must not be disposed of with household waste. Return it to an approved recycling point for electrical and electronic devices at the end of its life.
9. [Safety Class II Symbol] This light is specially insulated and must not be connected to an earthed conductor.
10. Terminal identification: L = Phase, N = Neutral conductor, G = [Earthed Conductor Symbol].
11. Protective covers and end caps for mains voltage carrying parts must always be mounted.
12. Do not install the light on a damp or conductive subsurface.
13. Ensure cables are not damaged during installation.
14. The light has a protection rating of "IP20" and is intended exclusively for indoor use in private households.
15. Do not look directly into the light source (bulb, LED, etc.).
16. [Light Source Symbol] The light source of this lamp is not replaceable; when the light source reaches its end of life, the entire luminaire must be replaced.
17. This product contains a light source of energy efficiency class "D" (EU Regulation 2019/2015).
18. Color deviations may occur with LEDs from different batches. Light color and brightness can also change depending on the lifespan.
19. [Dimmable Circuit Symbol] This article is not suitable for use in dimmable circuits.

Contact Information

For any issues or further information, please contact:

Briloner Leuchten GmbH & Co. KG
Am Steinbach 14
D-59872 Meschede

Customer Hotline: 00800/27456637 (00800/BRILONER)

Revision: 04_09/2022