MAL 3362-116 LED Ceiling Light with Motion Detector

Customer Information

For any issues or defects, please contact Briloner Leuchten at 00800/BRILONER (00800/27456637), providing your purchase date, location, and product article number.

Address: Briloner Leuchten / Im Kissen 2 / 59929 Brilon

Safety Instructions

Please read these instructions carefully before installation or use. Keep this manual for future reference.

• Installation must be performed only by authorized and qualified technicians according to valid electrical installation regulations.
• The manufacturer is not responsible for injuries or damage resulting from improper use.
• Maintenance is limited to cleaning surfaces. Ensure no moisture enters connection areas or contacts live parts.
• Attention: Before starting installation, switch off the mains power supply (turn off safety cutout or remove fuse). Ensure the switch is "OFF".
• Warning: Before drilling mounting holes, check for hidden gas, water, or electricity pipes/wires that could be damaged.
• When mounting, ensure the fixture's attachment material is suitable for the subsurface and that the subsurface has adequate load-bearing capacity. The manufacturer is not liable for improper installation.
• The symbol of a crossed-out garbage can ?️ indicates that this product must not be disposed of with household waste. It must be returned to an approved recycling point for electrical and electronic devices at the end of its life.
• Protection Class: Safety Class I ⚡. This light must be connected to the earthed conductor terminal (green-yellow wire) ⏚.
• Terminal Designation: L = Phase, N = Neutral conductor, G = Earthed conductor.
• Protective covers and end covers for mains voltage parts must always be mounted.
• Do not install the light on a damp or conductive subsurface.
• Ensure cables are not damaged during installation.
• Attention: Lamp parts and illuminants can reach temperatures exceeding 60°C during operation. Do not touch during operation ?.
• The light has a protection class rating of "IP44" and is intended for indoor use only in private households.
• Do not look directly into the light source (illuminant, LED, etc.) ?.
• The light source of this lamp is not replaceable. If the light source reaches the end of its operational life, the entire lamp must be replaced.
• LED color deviations may occur between different batches. Light color and luminous strength can also change over the lifespan of the LED.
• This lamp is not suitable for dimmers or electronic switches.
• This is a light with a motion detector ?.
• Motion Detector Operation:
  • The operating period for the connected load upon detected motion is adjustable from "5" seconds to "10" minutes ⏱️.
  • If new motion is detected during the active period, the duration is extended by the set time.
  • The motion sensor activates when the ambient light level is between "<25 Lux" and ">>25 Lux" (adjustable) ☀️.
  • After power-on, the motion sensor requires approximately "10" seconds to warm up and function correctly. The connected load will be switched on for this duration before the sensor enters automatic mode.

Features

• Integrated motion detector with adjustable sensitivity, time delay, and lux level.
• IP44 rated for indoor use.
• Energy-efficient LED technology.
• Durable construction.

Motion Detector Settings

The motion detector features adjustable controls:

• SENS: Adjusts the sensitivity of the motion detection range.
• TIME: Sets the duration the light stays on after motion is detected (5 seconds to 10 minutes).
• LUX: Sets the ambient light level at which the motion detector becomes active (from <25 Lux to >25 Lux).

Diagram Description

The diagram illustrates the components of the light fixture, including the main housing, the motion sensor lens, and the terminal block for electrical connections (L, N, G). It also shows the location of the SENS, TIME, and LUX adjustment dials for the motion detector.