Briloner MAL 3701 LED Ceiling Light
Installation and User Manual
Product Description
The Briloner MAL 3701 is an LED ceiling light designed for indoor use. It offers adjustable color temperature, dimming, a timer function, a night light mode, and a memory function, all controllable via an included remote control.
Key Features:
- Adjustable Color Temperature: 3000K (Warm White) to 6500K (Cool White)
- Dimmable: Brightness adjustable from 20% to 100%
- Timer: Automatic shut-off after approximately 30 minutes
- Night Light Mode: Very low brightness setting (approx. 3000K)
- Memory Function: Remembers the last setting after a short power interruption
- Remote Control Included
- Power Source: 2 x AAA 1.5V batteries (not included for remote)
- Protection Class: IP20
- Energy Efficiency Class: E
Safety Precautions
⚠️ Important Safety Instructions:
- Installation must be performed by qualified personnel following electrical regulations.
- Do not use if the light or cable is damaged.
- Disconnect power before installation or maintenance.
- Ensure no gas, water, or electrical pipes are present before drilling.
- Use only appropriate mounting materials suitable for the subsurface.
- Clean only with a dry, lint-free cloth. Do not use water or liquids.
- Lamp parts can reach temperatures over 60°C during operation; do not touch.
- Do not look directly into the light source.
- The LED light source should only be replaced by authorized personnel.
- This product is for indoor use only.
- Dispose of electronic waste responsibly.
Installation Guide
Follow these steps for installation:
- Ensure power is disconnected.
- Mount the bracket to the ceiling using suitable screws.
- Connect the wires: L (Phase) to L, N (Neutral) to N, and G (Ground) to G.
- Secure the light fixture to the bracket.
- Restore power.
Diagram Description: The diagram illustrates the mounting process. It shows a circular ceiling light fixture with a central mounting plate. Wires labeled L (Phase), N (Neutral), and G (Ground) are depicted connecting to the fixture's terminals. The mounting bracket is shown being attached to a ceiling surface.
Operating the Light
The included remote control offers several functions:
- ON/OFF: Powers the light on/off, recalling the last setting.
- WW/NW/CW: Cycles through color temperatures: Warm White (WW), Neutral White (NW), and Cool White (CW), corresponding to 3000K, 4000K, and 6500K respectively.
- Timer: Sets the light to turn off automatically after approximately 30 minutes. A single flash of the LED confirms activation.
- Bright / Dim: Adjusts the light's brightness up or down, either in steps or smoothly.
- Cool / Warm: Adjusts the color temperature towards cooler or warmer tones, either in steps or smoothly.
- Night Light: Activates a low-brightness mode (approx. 3000K).
- 20% / 50% / 100%: Directly sets the brightness level to 20%, 50%, or 100%.
- 3000K / 4000K / 6500K: Directly sets the color temperature to the specified Kelvin value.
Color Temperature Adjustment via Power Cycling: The color temperature can also be changed by switching the light off and on again within approximately 1 second. The sequence is: 6500K → 3000K → 4000K → Night Light (3000K) → 6500K, and so on.
Memory Function: If the light is switched off for at least 5 seconds using an external wall switch, it will resume its last selected setting when turned back on.
Contact Information
For customer support or warranty inquiries, please contact Briloner Leuchten:
Address: Im Kissen 2, 59929 Brilon
Hotline: 00800/BRILONER (00800/27456637)
Please have your purchase date, place of purchase, and product article number ready.
