DIMLITE pro G2 TEC2 Mounting Instructions

General Information and Safety Notices

ℹ️ Important notices. Please, read first! Keep the instructions safe! Specifications are subject to change without notice! If you have questions, please contact the manufacturer.

The installation and commissioning of the luminaire, as well as any modification, may only be performed by authorized personnel (qualified electrician). National installation regulations must be observed. Before any work on the appliance is done, it must be disconnected from mains.

⚠️ Hot plug-in is not an option and may cause damage to the lamp or luminaire! The manufacturer is not liable for damages resulting from improper or faulty installation or operation or from unauthorized modifications.

⚠️ Caution, risk of electric shock!

Dimensions

The luminaire has the following approximate dimensions:

• Length: 250 mm
• Width: 60 mm
• Height/Depth: 14 mm

Chemical Resistance: Use only cleaning agents suitable for plastics. Respect the chemical resistance of the material.

Mounting Instructions

Step 1: Prepare the Track and Connector

1a. Start Track Connection: Identify the start track. Insert the electrical connector into the designated slot on the track. The connector typically has terminals for L1, L2, L3, N, PE, EL1, EL2, EN1, EN2. Ensure correct wiring according to diagrams. A visual check confirms correct alignment.

1b. Mechanical Engagement: The connector module is designed for easy mechanical engagement. It can be inserted or removed by applying pressure or pulling, often with a click mechanism.

1c. CLIX Connection: The "CLIX" system facilitates secure electrical connection. Ensure the connector is properly seated and locked into place. A visual indicator or audible click may confirm engagement.

Step 2: Connect Luminaire to Track

2a. Track Connection: Similar to step 1, prepare the luminaire's connection point and the track. Ensure correct polarity and wiring are maintained. Diagrams show comparisons of correct and incorrect connection configurations.

2b. CLIX Mechanism: The luminaire features a "CLIX" connector. Push the luminaire towards the track connection point until it clicks into place, establishing the electrical and mechanical link.

2c. Secure Connection: Apply firm, even pressure to connect the luminaire. The mechanism is designed for a secure fit.

2d. Wiring Verification: Double-check all electrical connections (L1, L2, L3, N, PE, EN1, EN2, EL1, EL2) against the required configuration for the luminaire and the track system. Incorrect wiring can lead to damage or malfunction. The diagram shows correct wiring for AC 220-240 V.

Step 3: Install Luminaire onto Track System

3a. Mounting: Align the luminaire with the track system. Slide or attach the luminaire onto the track. Arrows indicate the direction of insertion.

3b & 3c. Securing: Ensure the luminaire is correctly seated and secured on the track. A locking mechanism may be present to prevent accidental detachment.

Dismounting

To remove the luminaire:

1. Release the locking mechanism (indicated by a lock icon ? and number 1).
2. Pull the luminaire away from the track (indicated by number 2).

Optional Features

DALI MSENS TEC2

This section describes the optional DALI MSENS TEC2 sensor system, which can be integrated with the luminaire. Diagrams illustrate sensor coverage within a room.

Maximum System Capacity:

APP Integration

Commissioning and Remote Control

The DIMLITE pro G2 system can be commissioned and controlled using dedicated mobile applications for Android and iOS devices. These apps allow for setup and remote operation within a range of approximately 15 meters.

Diagrams show a room with a door and a smartphone indicating wireless control and signal range.

Technical Specifications and Operation

Electrical Connection: The luminaire operates on AC 220-240 V.

Operation: Follow all installation and operation instructions carefully. Ensure the luminaire is installed by qualified personnel.