Zumtobel PANOS R R150/200 AE D1000/25 Mounting Instructions

Product Information

Model: PANOS R R150/200 AE D1000/25

Manufacturer: Zumtobel Lighting GmbH

Address: Schweizer Strasse 30, 6851 Dornbirn AUSTRIA

Mounting Overview

The luminaire requires mounting using specific components and procedures. Ensure all parts are present before beginning.

Components:

• 3x Mounting screws
• 3x Wall plugs
• 3x Fasteners
• 3x Cable connectors

Dimensions:

• Diameter: Ø1000mm
• Height: 40mm
• R150: 2x
• R200: 3x

Mounting Steps:

1. Step a: Mark the mounting points on the ceiling. Ensure the surface is suitable for the load.
2. Step b: Install wall plugs and fasteners at the marked points.
3. Step c: Attach the mounting bracket to the ceiling.
4. Step d: Secure the luminaire to the mounting bracket.
5. Step e: Connect the electrical wiring. Torque specification: 1.2 Nm.
6. Step f: Insert the luminaire into the mounting bracket.
7. Step g: Ensure the luminaire is level and securely attached. Maximum tilt angle: 15°.
8. Step h: Final connection and securing of the luminaire.

Additional Safety Information

Please note the additional safety information in the mounting instructions for the luminaire. This includes:

• Observe the further safety instructions in the mounting instructions for the luminaire.
• Ensure proper electrical connections.
• Verify secure attachment to the ceiling.

Assembly Diagrams

The assembly process is illustrated in a series of diagrams:

• Diagram 1: Shows the components and initial steps for mounting.
• Diagram 2-7: Illustrate the sequential assembly of the luminaire components.
• Diagram 8: Demonstrates correct and incorrect mounting angles and connections.
• Diagram 9: Provides an overview of different PANOS R models.