Ideal Lux Mapa Sat SP3 Suspension Lamp

Product Information

Brand: Ideal Lux

Model: Mapa Sat SP3

Type: Suspension Lamp

Dimensions: Height: 1320 mm, Diameter: 550 mm

Bulb Type: E27

Max Wattage: 3 x 60W

Voltage: 220-240V

Frequency: 50/60Hz

Available Finishes: Nickel (8021696176031), Brass (8021696175973)

Certifications: CE marking

Ingress Protection: IP20

Revision Date: 18/10/2023

Assembly Instructions

Follow the progressive order of operations for assembly.

1. Ensure installation is performed by a qualified electrician.
2. Disconnect power before starting installation or any maintenance.
3. Mount the fixture base to the ceiling using appropriate fixings for your ceiling material.
4. Connect the electrical wires (Live, Neutral, Earth) according to the wiring diagram.
5. Adjust the suspension chain and electrical cable so that the cable is longer than the chain.
6. Attach the lamp body or shades to the fixture.
7. Install the light bulbs (E27, max 60W each), ensuring they do not exceed the maximum wattage and maintain the recommended safety distance from illuminated objects.
8. If the safety glass is cracked or broken, it must be replaced immediately with manufacturer-approved parts.

Important Safety Note: The safety and reliability of this appliance are guaranteed only when installation instructions are properly followed. Please keep this instruction sheet for future reference.

Safety Instructions

• This fitting complies with European safety standards EN 60598-1.
• Do not dispose of this fitting as household waste; consult local authorities for disposal information.
• Installation must be carried out by a qualified electrician.
• If the external wire is damaged, it must be replaced exclusively by the manufacturer, distributor, or a qualified electrician.
• Always isolate power before commencing installation, maintenance, or repair.
• The luminaire contains parts that can become very hot.
• Use mounting accessories suitable for your ceiling/wall material; included accessories may be unsuitable.
• Firmly tighten all screws to avoid contact problems.
• This fitting is for indoor use only.
• Not suitable for recessed installation or direct mounting on normally flammable surfaces.
• Suitable for ceiling or wall mounting.
• The lamp's weight must be supported by the chain; adjust the electric wire to be longer than the chain.
• Only use bulbs that do not exceed the maximum specified wattage.
• Maintain the minimum safety distance between the bulb and the illuminated object as indicated by the icon to prevent fire hazards.
• Use only auto-protected bulbs marked with the specific symbol. Halogen bulbs get very hot; wait for them to cool before replacing.
• Replace cracked or broken safety glass immediately with manufacturer-approved parts.
• The light source (LED) is not replaceable. Do not disassemble the product as diodes can damage eyes. Do not immerse in water. Clean with a damp cloth, avoiding solvents and strong detergents.
• If the lamp does not light up, check and replace the fuse if applicable.
• Electrical Safety Classes:
• Class I: Requires earthing connection.
• Class II: Double or reinforced insulation, earthing not required.
• Class III: Low voltage supply (under 50V), earthing not required.
• Ingress Protection (IP) Ratings:
• IP20: Protected against solid objects greater than 12.5mm, not protected against water.
• Do not cover the luminaire with thermally insulating material.
• Caution: Risk of electric shock.
• Do not stare directly at the operating light source.