Ideal Lux Smarties SP5 D60 Suspension Lamp

Product Information

• Type: Suspension Lamp
• Bulb Type: E27
• Max Wattage: 5 x 60W
• Voltage: 220-240V
• Frequency: 50/60Hz
• Color: Bianco (White)
• Diameter: 600mm
• IP Rating: IP20

Assembly Instructions

Important: Follow the assembly instructions by reading the numerical progression. The lighting fitting should be installed by a qualified electrician.

Step-by-Step Guide:

1. Step 1: Prepare the mounting base. Ensure power is disconnected.
2. Step 2: Attach the mounting bracket to the ceiling or wall as appropriate.
3. Step 3: Connect the electrical wires (Live, Neutral, Earth) according to local electrical codes and the diagram. Ensure secure connections.
4. Step 4: Attach the suspension chain to the lamp body and the ceiling support. Adjust the electrical cable length to be longer than the chain.
5. Step 5: Mount the lamp body onto the prepared base/bracket.
6. Step 6: Install the lamp shades or diffusers.
7. Step 7: Insert the specified bulbs (E27, max 60W each).
8. Step 8: Restore power and test the lamp.
9. Step 9: (Diagrams 5-13 show detailed steps for attaching arms, wiring, and securing components. Refer to the visual diagrams for precise placement and connections.)

Safety Information

General Safety: The safety and reliability of this appliance are guaranteed only when installation instructions are properly followed. Please keep this instruction sheet for future reference.

Key Safety Points:

• This fitting complies with European safety standards EN 60598-1.
• Do not dispose of this fitting as household waste. Consult local authorities for proper disposal methods.
• Installation must be performed by a qualified electrician.
• Always disconnect power before installation, maintenance, or repair.
• The luminaire may contain parts that can become hot. Handle with care.
• Use appropriate mounting accessories suitable for your wall/ceiling material. Included accessories may not be suitable.
• Ensure all screws are tightened firmly to avoid contact problems.
• This fitting is designed for indoor use only.
• Do not install on or near flammable surfaces.
• The lamp's weight must be supported by the chain; ensure the electrical cable is longer than the chain.
• Use only bulbs with a wattage not exceeding the specified maximum (60W per socket).
• Maintain the minimum safety distance between the bulb and illuminated objects as indicated by the icon to prevent fire hazards.
• For bulbs that get very hot (e.g., halogen), allow them to cool down before replacement.
• If safety glass is cracked or broken, replace it immediately with manufacturer-approved parts.
• The light source (LED) is not replaceable. Do not disassemble the product as LEDs can cause eye damage.
• Do not immerse the product in water. Clean with a damp cloth, avoiding strong solvents or detergents.
• If the lamp does not light, check and replace the fuse if necessary.
• Electrical Safety Classes: Ensure compliance with Class I, II, or III requirements as applicable, including earthing where required.
• IP Rating (IP20): Protected against solid objects greater than 2.5mm, but not protected against water.
• Caution: Risk of electric shock ⚡.
• Warning: Do not stare directly at the operating light source ⚠️.

Manufacturer Information

Company: IDEAL LUX s.r.l.

Address: Via Taglio Destro 32, 30035 Mirano (VE), Italy

Website: www.ideal-lux.com

Warehouse: Via delle Industrie, 8/D, 30036 Santa Maria di Sala (Venezia)