Ideal Lux Luce Max SP1 Big Suspension Lamp

Product Overview

The Luce Max SP1 Big is a suspension lamp designed by Ideal Lux. This document provides instructions for its safe installation and use.

Technical Specifications

• Product Name: Luce Max SP1 Big
• Brand: Ideal Lux
• Type: Suspension Lamp
• Bulb Holder: E27
• Max Wattage: 1 x 60W
• Voltage: 220-240V
• Frequency: 50/60Hz
• IP Rating: IP20 (Protected against solid objects larger than 12.5mm, no protection against water.)
• Color/Finish: Transparent
• Model Number: 8021696033662
• Certifications: CE certified

Important Safety Instructions

Read all instructions carefully before installation. Keep this instruction sheet for future reference.

• The safety and reliability of this appliance are guaranteed only when installation instructions are properly followed.
• Installation must be performed by a qualified electrician.
• Always disconnect power before commencing installation, maintenance, or repair.
• This fitting should only be installed indoors.
• Do not use bulbs exceeding the maximum specified wattage (60W).
• Always observe the minimum safe distance between the bulb and the illuminated object, as indicated by the icon, to prevent fire hazards.
• Do not stare directly at the operating light source.
• If the external wire is damaged, it must be replaced exclusively by the manufacturer, distributor, or a qualified electrician.
• The luminaire contains parts that can become very hot.
• Use mounting accessories suitable for the material to which the fixture is fastened; included accessories may be unsuitable.
• Always tighten screws firmly to avoid contact problems.
• If safety glass is cracked or broken, replace it immediately with manufacturer-approved parts complying with regulations.
• Light source with not-substitutable light emitting diode (LED). Do not disassemble the product as diodes can damage eyes.
• Do not immerse in water. Clean with a damp cloth, avoiding solvents and strong detergents.
• This fitting is equipped with a fuse. If the lamp is out of order, replace the internal fuse.
• Electrical safety classes: Class I (requires earthing), Class II (double/reinforced insulation, no earthing required), Class III (low voltage, no earthing required). This fixture is Class I.

Installation Steps

Follow the assembly instructions by reading the numerical progression. Installation must be performed by a qualified electrician.

1. Step 1: Mount the Ceiling Bracket

   Secure the provided mounting bracket to the ceiling using appropriate fixings suitable for your ceiling material. The diagram shows the bracket being attached to the ceiling.

2. Step 2: Connect the Wiring

   Route the electrical supply wires through the ceiling opening. Connect the Live wire (L) to the 'L' terminal, the Neutral wire (N) to the 'N' terminal, and the Earth wire (⏚) to the Earth terminal. Ensure all connections are secure.

3. Step 3: Attach the Lamp Body

   Secure the lamp's canopy to the mounting bracket, ensuring all wires are neatly tucked away.

4. Step 4: Adjust Cable Length

   Adjust the length of the suspension cable and electrical wire as needed. Ensure the electrical wire is longer than the suspension cable. Secure the cable in place.

5. Step 5: Install the Light Bulb

   With the power off, screw in an E27 bulb. Ensure the bulb's wattage does not exceed the maximum specified limit of 60W.

6. Step 6: Final Check

   Restore power and test the lamp to ensure it functions correctly.

Care and Maintenance

Clean the lamp with a soft, damp cloth. Avoid using solvents or harsh cleaning agents.