Ideal Lux Mapa Bianco SP1 D40

Important Safety Information

The safety and reliability of this appliance are guaranteed only when installation instructions are properly followed. Please keep this instruction sheet for future reference. Installation must be performed by a qualified electrician.

Assembly Instructions

Follow the assembly steps by reading the numerical progression. Ensure all operations are performed in the correct order.

1. Step 1: Mount the ceiling bracket securely to the ceiling using appropriate hardware.
2. Step 2: Connect the electrical wires. Strip approximately 0.5 cm of insulation from the ends of the wires. Connect the live (L), neutral (N), and earth (if applicable) wires from the ceiling supply to the corresponding terminals on the fixture's terminal block. Ensure secure connections.
3. Step 3: Adjust the suspension cable length to the desired height. Ensure the electrical wire is longer than the suspension cable or chain.
4. Step 4: Attach the main body of the lamp to the ceiling mounting bracket.
5. Step 5: Install the light bulb (E27, max 60W).
6. Step 6: Carefully attach the glass diffuser or shade to the lamp body.
7. Step 7: Ensure all screws are tightened firmly to avoid contact problems.
8. Step 8: The installation must be completed by a qualified electrician.

Safety Guidelines

• Always disconnect the power supply before starting installation or any maintenance.
• This luminaire contains parts that can become hot.
• Use mounting accessories suitable for the material to which the fixture is being fastened; the included accessories may be unsuitable.
• This fixture is intended for indoor use only.
• Do not install on normally flammable surfaces.
• The weight of the lamp must be supported by the chain. Adjust the electrical wire so it is longer than the chain.
• Only use lamps that do not exceed the maximum specified wattage.
• Always observe the minimum safety distance between the bulb and the illuminated object as indicated by the icon. Failure to do so may cause a fire.
• Use only bulbs marked with the auto-protected symbol if applicable. Halogen bulbs get very hot; wait for them to cool down before replacing.
• If safety glass is cracked or broken, it must be replaced immediately with manufacturer-approved parts.
• The light source (LED) is not replaceable. Do not disassemble the product, as LEDs can cause eye damage. Do not immerse in water. Clean with a damp cloth, avoiding solvents and strong detergents.
• The fixture is equipped with a fuse. If the lamp does not light up, replace the fuse.
• Electrical safety classes: Class I (requires earthing), Class II (double/reinforced insulation, no earthing required), Class III (low voltage, no earthing required).
• Ensure proper protection against solid objects and water ingress as indicated by IP ratings.
• Do not cover the luminaire with thermally insulating material.
• Caution: Risk of electric shock. Do not stare at the operating light source.