PLATSA

Important Safety Information

⚠️ WARNING! Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.

Screw(s) and plug(s) for the wall are not included. Use screw(s) and plug(s) suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instruction carefully.

Tools Required

• Screwdriver
• Spirit level
• Tape

Parts List

The following parts are included in the package:

• 8 x Cam lock screws (Part #114142)
• 8 x Cam locks (Part #100092)
• 2 x Back panels (Part #194732)
• 4 x Shelf supports (Part #10044713 / #10100447)
• 4 x Wall mounting brackets (e.g., Part #10042534, #10042566, #10100681)
• 4 x Screws for wall mounting (e.g., Part #108736)
• 4 x Other screws (Part #10044727 / #10100556)
• 4 x Other screws (Part #10042534)
• Connecting hardware for stacking (e.g., Part #152059)

Note: Wall mounting screws and plugs are not included and must be purchased separately based on your wall type.

Assembly Steps

1. Assembling the Basic Unit Frame

1. Connect the base panel to one side panel using two cam lock screws (#114142) and two cam locks (#100092). Repeat for the other side panel.
2. Slide the back panel (#194732) into the grooves on the side panels.
3. Attach the top panel to the side panels using two cam lock screws (#114142) and two cam locks (#100092) on each side.
4. Attach the second side panel to the base and top panels using cam lock screws (#114142) and cam locks (#100092).
5. Insert the second back panel (#194732) into the grooves of the side panels.

2. Installing Shelves

6. Insert shelf supports (#10044713 / #10100447) into the desired pre-drilled holes on the inside of the unit.
7. Place the shelves onto the installed shelf supports.

3. Wall Mounting

Crucial Step: To prevent tip-over accidents, it is essential to secure the furniture to the wall.

8. Attach the wall mounting brackets (e.g., #10042534, #10042566, #10100681) to the top rear of the unit using screws (e.g., #108736).
9. Position the unit against the wall. Use a spirit level to ensure it is vertical.
10. Mark the wall through the bracket holes.
11. Secure the unit to the wall using appropriate screws and wall plugs suitable for your wall type (not included).

4. Stacking Units

The PLATSA system allows for stacking multiple units.

12. To stack units, attach connecting hardware (e.g., #152059) to the top of the lower unit.
13. Place the next unit on top, aligning the connecting hardware to secure them together.

The maximum recommended stack height for PLATSA units is 300 cm (118 7/64").