Step 1: Assemble Base Frame
Connect the side panels to the base panel using four screws (114142) and dowels (100092). Ensure correct orientation.
Important Safety Information
[!] WARNING!
Serious or fatal crushing injuries can occur from furniture tip over. To prevent tip over, this furniture must be used with the wall attachment device(s) provided.
Screws and plugs for the wall are not included. Use screws and plugs suitable for your walls. If you are uncertain, seek professional advice. Read and follow each step of the instructions carefully.
Parts and Hardware
The following components and hardware are typically included. Please refer to the diagrams in the original document for visual identification and exact quantities.
- Frame components (side panels, top, base)
- Mesh shelves
- Screws (e.g., 114142, 100092, 108736, 152059)
- Dowels/Plugs (e.g., 194732)
- Connectors/Brackets (e.g., 10044727, 10044713, 10042534, 10042568, 10046332)
- Hex key (e.g., 10042534)
Note: Wall mounting screws and plugs are not included and must be purchased separately based on your wall type.
Assembly Steps
Follow these steps to assemble your PLATSA unit:
Step 2: Attach Mesh Side Panels
Insert two dowels (194732) into the side panels and attach the mesh side panels.
Step 3: Attach Top Panel
Secure the top panel to the assembled frame.
Step 4: Secure Main Frame
Use four screws (114142) to reinforce the main frame structure.
Step 5: Insert Shelves
Insert two dowels (194732) into the side panels and slide the shelves into place.
Step 6: Attach Support/Back Panel
Attach the support or back panel using the provided connectors (e.g., 10044713). This step often involves a "click" sound indicating secure attachment.
Step 7: Install Shelf Supports
Attach the supports for the shelves using eight sets of components (four of part 10042568 and four of part 10042534).
Steps 8-11: Insert Remaining Shelves
Continue inserting the remaining shelves into the unit, ensuring they are properly seated and secured with the shelf supports.
Step 12: Complete Unit Assembly
The primary structure of the PLATSA unit is now complete.
Step 13: Leveling
Position the unit and ensure it is level. Adjust the feet if necessary for stability.
Steps 14-15: Position Unit
Move the assembled unit to its final location, typically against a wall.
Steps 16-25: Wall Attachment (Crucial Safety Step)
[!] It is essential to secure the unit to the wall to prevent tip-over injuries. Use the provided wall attachment hardware (e.g., brackets like 10046332, connectors like 10044713, 10042568, 10042534). Ensure you use appropriate screws and wall plugs that are compatible with your specific wall material. If unsure, consult a professional.
Step 26: Stacking and Configuration
Multiple PLATSA units can be combined to create larger storage solutions. The maximum recommended stacking height for PLATSA units is 300 cm (118 7/64").
Steps 27-28: Connecting Multiple Units
Use the provided hardware (e.g., 152059, 108736) to connect multiple PLATSA units together securely.
Dimensions
Approximate dimensions of a single PLATSA unit: Width: 800 mm (31 1/2"), Height: 600 mm (23 5/8"), Depth: 109 mm (4 19/64").
