Package Include:
- A × 1PC
- Bench Seat Frame
- B × 4PCS
- Bench Legs
- C × 1PC
- Cross Brace
- D × 2PCS
- Backrest Panels (Vertical Slats)
- E × 1PC
- Left Backrest Arm/Top Rail
- F × 1PC
- Right Backrest Arm/Top Rail
- G × 1PC
- Backrest Support Bar
- H × 12PCS
- M8 Nuts (Note: M8 nuts are fixed on the product; please unscrew them before installation.)
- I × 4PCS
- M6*25mm Screws
- J × 8PCS
- M8*15mm Screws (Note: M8*15mm screws are fixed on the product; please unscrew them before installation.)
- K × 2PCS
- M6*20mm Screws (Note: M6*20mm screws are fixed on the product; please unscrew them before installation.)
- L × 1PC
- L-shaped Hex Wrench
- M × 1PC
- Open-end Wrench
- N × 1PC
- Backrest Support Bracket
Assembly Steps:
Step 1: Attach Legs to Seat Frame
Place the Bench Seat Frame (A) upside down. Attach each of the four Bench Legs (B) to the corners of the frame. Secure them using the M8 Nuts (H). Use the Open-end Wrench (M) to tighten the nuts. Ensure all four legs are firmly attached.
Step 2: Install Cross Brace
With the bench still upside down, attach the Cross Brace (C) between the legs. Align the holes on the Cross Brace with the corresponding holes on the Bench Legs (B). Secure the Cross Brace using the remaining M8 Nuts (H). Use the Open-end Wrench (M) to tighten the nuts securely.
Step 3: Assemble and Attach Backrest
Carefully turn the bench upright. Attach the Backrest Panels (D) to the back of the seat frame. Connect the Left Backrest Arm/Top Rail (E) and Right Backrest Arm/Top Rail (F) to the top of the backrest panels and the sides of the seat frame. Use the M6*25mm Screws (I) to attach the backrest components. Secure the Backrest Support Bar (G) to the lower back of the seat frame using M8*15mm Screws (J). Finally, attach the Backrest Support Bracket (N) to the backrest structure using M6*20mm Screws (K). Use the L-shaped Hex Wrench (L) for the hex screws and the Open-end Wrench (M) for the nuts as needed to ensure all backrest components are securely fastened.
