micro bit MakeCode Keyboard Controls
Informasi Produk
Spesifikasi:
- Sistem Operasi: Windows
- Control Method: Keyboard Controls
- Compatibility: MakeCode Editor
Buat proyek baru
In the MakeCode editor, press Tab to reach + New Project, then press Enter.
Type a name for your project, then press Enter. 
Turn on blocks keyboard controls
Press Tab, then press Enter. 
Open or close keyboard controls help
Hold Ctrl and press 
Tip: If you have space on your screen then keep the help open
Kontrol umum
Workspace: General controls
In the workspace, use general controls as needed
| Tindakan | Jalan pintas |
| Memotong | tombol kontrol + X |
| Menyalin | tombol kontrol + C |
| Pasta | tombol kontrol + V |
| Membuka | tombol kontrol + Z |
| Mengulangi | tombol kontrol + Y |
| Open context menu (right-click menu) | tombol kontrol + Memasuki |
| Duplikat | D |
| Next stack of blocks | N |
| Previous stack of blocks | B |
Navigate to an area: Option 1
Make Code Keyboard Controls Navigate to an area: Option 1
Navigate to an area: Option 2
Hold Ctrl + B, press Tab to move through the numbers, and then press Enter to confirm.
Workspace: Select the workspace
Tekan tombol W.
Workspace: Format (tidy up) blocks
Press the F key. 
Access parts of a block
Workspace: Access parts of a block
Use the arrow keys to access different parts of a block.
Ruang kerja: Move a block
Press M, then use the arrow keys to move a block. Press Enter to confirm. 
Workspace: Move a block anywhere
- Press M, then hold Ctrl and use the arrow keys.
- Tekan Enter untuk konfirmasi.
Workspace: Disconnect a block
Press X to disconnect a block 
Workspace: Delete a block
Press Delete or BackSpace to remove a block 
Workspace: Edit or confirm
Press Enter or Space to confirm an action 
Workspace: Block navigation
Use arrow keys to navigate blocks
Toolbox: Access the toolbox
Press T or hold Ctrl + B then press 3 
Toolbox: Navigation
Use arrow keys to navigate categories and blocks 
Toolbox: Select or confirm a block
Press Enter or Space to select a block 
Toolbox: Search
- In the toolbox (T), start typing the name of a block.
- Press Enter to move to results.
- Press down arrows to select a block. Press Enter to confirm.
Specific blocks: Show LEDs block
- Use right arrow key then Enter to access LED editor.
- Use arrows to navigate LEDs.
- Press Enter to turn LED on and off.
- Press Esc to exit.
Specific blocks: Play melody
- Use right arrow to move to the melody. Press Enter to open melody.
- Press Tab to edit melody. Use arrows to select a note.
- Press Enter to confirm note.
- When finished, Tab to Done and press Enter.
Mikro:bit Educational Foundation mbit.io/makecode-keys This content is published under a Creative Commons Attribution-ShareAlike 4.0 International (CC BY-SA 4.0) licence
Pertanyaan yang Sering Diajukan
How do I access different parts of a block in the workspace?
Use the arrow keys to navigate through different parts of a block.
How do I delete a block in the workspace?
To delete a block, press Delete or BackSpace.
Dokumen / Sumber Daya
 |
micro bit MakeCode Keyboard Controls [Bahasa Indonesia:] Panduan Pemilik MakeCode Keyboard Controls, Keyboard Controls, Controls |