FIRElood specializes in electric heating combustion tools, offering high-quality wood burning kits, pyrography machines, and styrofoam cutting pens for crafting.
FIRElood is a specialized manufacturing brand with over 30 years of practical experience in the development and production of electric heating and hot stamping combustion tool kits. The brand is known for its high-quality, cost-effective wood burning kits, leather pyrography sets, and styrofoam hot wire cutting pens.
Catering specifically to artists, DIY enthusiasts, and hobbyists, FIRElood provides specialized tools equipped with adjustable temperature regulators and multi-functional wire tips designed for precise rendering, shading, and cutting on various materials like wood, leather, and foam. Browse our collection of user manuals to safely set up, maintain, and troubleshoot your FIRElood crafting tools.
Latest manuals from manuals+ curated for this brand.
Common questions about manuals, registration, and support for this brand.
This is typically caused by improper tip installation that results in an incomplete electrical circuit. Ensure that the two pins of the wire tip are inserted all the way to the bottom of the pen sockets, and firmly tighten the securing screws to hold both pins evenly.
Use the temperature regulator on the machine base. For low-temperature rendering, adjust between 250-400°C depending on material density. Lower temperatures are ideal for gradual shading, while higher temperatures (around 600°C) are typically used for dark, prominent line drawing.
Yes, but you must bend it carefully. Do not bend it repeatedly at the same point or fold it at a sharp right angle, as this will break the wire. When bending, ensure a gentle rounded corner (greater than R5MM) to protect the heating element.
The hot pen is designed for low-density melting materials such as pearl cotton, KT board, foam board, extruded board, and chemical fiber cloths. Do not attempt to use it on non-melting hard materials.
Avoid working continuously for periods longer than 30 minutes without a break. Turn the power off and let the pen cool for 5 minutes. Additionally, clean the tips carefully using a damp, soaked sponge while avoiding applying excessive pressure that could break the heated metal wire.