Lightailing LED Lighting Kit for Lamborghini Revuelto Super Sports Car (42214)

Initial Steps (Steps 1-4)

Preparation and identification of block parts and the model.

Steps 1-4: Identify the included "Block Parts" which consist of LEDs, wires, and connectors. Prepare the Lamborghini Revuelto model for lighting integration.

Rear and Side Integration (Steps 5-12)

Focuses on installing lights and routing wires around the rear wheel assembly and side panels.

Steps 5-8: Route wires around the rear chassis and wheel areas, securing them as you proceed.

Steps 9-12: Install LEDs into designated points on the rear and side of the model, connecting the associated wiring.

Front End Integration (Steps 13-18)

Installation of lights for the front of the car, including headlights.

Steps 13-16: Install LEDs into the front light housings and route wires from the front LEDs towards the main connection points.

Steps 17-18: Secure the front lighting components and finalize the connections for the front lighting.

Internal Wiring and Body Assembly (Steps 19-28)

Connecting internal components, routing main wires, and reassembling body panels.

Steps 19-22: Connect various LED wires to central connection points or a distribution board, and route the main wiring harness through the model's interior or chassis.

Steps 23-26: Reattach body panels, carefully tucking wires to avoid pinching, and install LEDs in the engine bay or interior sections.

Steps 27-28: Finalize wiring connections in the rear or undercarriage, ensuring a clean installation.

Interior and Roof/Hood Integration (Steps 29-36)

Focuses on lighting elements within the cabin, hood, or roof structure.

Steps 29-32: Install LEDs and route wires for interior lighting or hood details, connecting them to main points.

Steps 33-36: Secure wiring and components in these areas, ensuring proper placement.

Final Connections and Testing (Steps 37-44)

Connecting the power source, final checks, and completion.

Steps 37-40: Make final connections to the battery pack or power module and connect the power source to the main wiring harness.

Steps 41-44: Connect the battery pack to the lighting system and perform a final test of all lights. Ensure all connections are secure and the model is fully assembled.