Lightailing LED Light Kit Installation Guide for LEGO Republic Juggernaut 75413

Pre-Installation Check

Before installation, please test each light to ensure it illuminates correctly. If any lights do not work, please contact customer support.

Installation Steps

Step 1: Prepare LED components and wires.

Step 2: Gather all necessary "Block Parts".

Step 3: Begin LEGO model assembly.

Step 4: Continue LEGO model assembly.

Step 5: Attach first LED lights and wires to chassis underside.

Step 6: Route wires along internal structure.

Step 7: Connect LED modules to model points.

Step 8: Secure wires in designated gaps.

Step 9: Install lights in the front section.

Step 10: Attach wires to the rear section.

Step 11: Route wires through the central body.

Step 12: Close-up of wiring connections.

Step 13: Install lights into side panels/doors.

Step 14: Route wires along seams.

Step 15: Attach lights to roof/upper sections.

Step 16: Secure loose wires.

Step 17: Install lights in engine/rear compartment.

Step 18: Connect wires to power distribution.

Step 19: Attach lights to wheel assembly.

Step 20: Route wires from wheels to body.

Step 21: Install lights in cockpit interior.

Step 22: Connect internal lighting components.

Step 23: Prepare smaller LED components.

Step 24: Attach smaller LEDs to specific points.

Step 25: Route wires for cockpit lighting.

Step 26: Connect cockpit wires to harness.

Step 27: Install lights into side cannons.

Step 28: Connect wiring for side lights.

Step 29: Close access panels after wiring.

Step 30: Attach final exterior lighting elements.

Step 31: Route wires for rear lights and power.

Step 32: Close-up of rear wiring.

Step 33: Install lights on top surface/antennas.

Step 34: Secure all external wiring neatly.

Step 35: Final front view check of installed lights.

Step 36: Show small LED components.

Step 37: Show small cylindrical components.

Step 38: Attach wiring to wheel assembly.

Step 39: Install lights in front landing gear.

Step 40: Connect wiring for front lights.

Step 41: Show cockpit interior wiring.

Step 42: Detail of a component (module/hub).

Step 43: Show section with multiple LED connection points.

Step 44: Show circular power modules.

Step 45: Show wire/LED arrangement (numbered 1-4).

Step 46: Connect wire 1 to component.

Step 47: Connect wire 2 to component.

Step 48: Connect wire 3 to component.

Step 49: Connect wire 4 to component.

Step 50: Show overall wiring harness connection.

Step 51: Connect main power cable.

Step 52: Show final power source connection.

Step 53: Install lights in rear hatch.

Step 54: Secure rear compartment LEDs.

Step 55: Show final rear wiring layout.

Step 56: Connect wires to power module.

Step 57: Show main power cable connection.

Step 58: Final power source connection.

Step 59: Completed model side view.

Step 60: Completed model front view.