Step2 Rushing Rapids Water Table™

Important Safety Information

This product is intended for children from 1½ years and up. Observe all statements and warnings to reduce the likelihood of serious or fatal injury. Save this sheet for future reference.

⚠️ WARNING: DROWNING HAZARD

There is a risk of young children drowning around open containers of water. Adult supervision is always required.

⚠️ WARNING: BURN HAZARD

Always check the temperature of the product before letting your children play with it. Remember that the product may cause burns if left in direct sunlight. Always be aware of the sun and weather conditions, and do not assume that the equipment is safe because the air temperature is not very high.

General Safety Guidelines

• Provide continuous adult supervision at all times.
• Instruct children not to use the product until properly assembled.
• The water table holds up to 4 gallons (15 liters) of water.
• Take the water table indoors or do not use it when the temperature drops below 32°F (0°C).

Cleaning Instructions

General Cleaning:

• Use a 50/50 mixture of white vinegar and water.
• Water should be changed frequently.
• Sanitize occasionally to remove organic debris and prevent bacterial growth.

Disposal Instructions

Please recycle when possible. Disposal must be in compliance with all government regulations.

Pre-Use Inspection

Inspect this product before each use. Tightly secure connections and replace damaged or worn components. Contact The Step2 Company for replacement parts.

Assembly Instructions

Follow these steps to assemble the Rushing Rapids Water Table. Refer to the diagrams for visual guidance on part identification (A, B, C, etc.) and fasteners (K1, K2, etc.).

Step 1-3: Attaching Legs

Secure the legs (A) to the base using fasteners (K1, K2). Ensure a tight fit to prevent leaks.

Step 4-6: Securing Base Components

Continue securing the base structure with the provided fasteners.

Step 7-8: Attaching Remaining Legs

Repeat the leg attachment process for the remaining legs (A) to ensure stability.

Step 9-12: Installing Water Channels and Supports

Attach the water channels (H, J) and support pieces (DR, DL) to the main structure. Ensure they snap securely into place.

Step 13-14: Adding More Water Channels

Connect additional water channels (J) to create the water flow paths.

Step 15-16: Installing Tower Structure

Mount the main tower components (F, E) onto the base.

Step 17: Attaching Crane Mechanism

Install the crane and bucket mechanism (C) onto the tower.

Step 18-20: Installing Gears and Spinning Elements

Attach the gear components (N1, N2) and spinning elements (M1, M2) to the appropriate sections of the water table.

Step 21-22: Attaching Water Wheel

Connect the water wheel assembly (L1, L2, T) to the tower structure. Press firmly until parts (L1) snap into place. ?

Step 23-24: Final Assembly Checks

Ensure all components are securely attached. The water wheel should spin freely.

Step 25: Attaching Accessories and Leg Removal

Attach final accessories like the scoop (S) and funnel (R). To remove legs, pull sideways to disengage.