STEP

WARNING: BURN HAZARD

Always check the temperature of the product before letting your children play with it. Remember that the product may cause burns if left in direct sunlight. Always be aware of the sun and weather conditions, and do not assume that the equipment is safe because the air temperature is not very high.

WARNING: DROWNING HAZARD

There is a risk of young children drowning around open containers of water. Adult supervision is always required.

Safety Information

• Provide continuous adult supervision at all times.
• Instruct children not to use product until properly assembled.
• Holds up to 4 gal. (15 l.) of water.
• Take indoors or do not use when the temperature drops below 32°F (0°C).

Cleaning Instructions

GENERAL CLEANING: Use a 50/50 mixture of white vinegar and water. Water should be changed frequently. Sanitize occasionally to remove organic debris and prevent bacterial growth.

Disposal Instructions

Please recycle when possible. Disposal must be in compliance with all government regulations.

Assembly Instructions

Parts Included:

• A: Water Table Base
• B: Legs (x3)
• C1: Drain Plug Screw
• C2: Wrench
• C3: Drain Plug Nut
• D: Slide
• E: Support Structure (x2)
• F: Support Structure (x2)
• G: Spinner Mechanism Base
• H: Base Insert
• I: Handle
• J: Crank
• K: Scoop

Assembly Steps:

1. Prepare the Base: Start with the main water table base (Part A). Locate the drain hole at the bottom. Insert the drain plug screw (C1) through the hole from the inside. From the outside, attach the drain plug nut (C3) and use the wrench (C2) to fully tighten the assembly to prevent leaks.
2. Attach Legs: Turn the base upright. Attach the three legs (B) to the designated mounting points on the underside of the base. These legs typically snap or screw securely into place.
3. Assemble Support Structure: Take the two support pieces (E) and the two support pieces (F). Connect these pieces together to form the main support frame. Attach the base insert (H) to the bottom of this assembled support frame.
4. Install Support Structure: Place this entire assembled support structure into the central cavity of the water table base (A).
5. Attach Slide and Accessories: Position the slide (D) onto the top of the assembled support structure and secure it. Assemble the water-cranking mechanism: Attach the crank (J) to the spinner base (G). Then, attach the handle (I) to the crank. Attach the scoop (K) to the spinner mechanism, usually on the side or integrated into the crank assembly. Ensure all components are firmly attached and secure. [Sound]

Final Inspection and Maintenance

INSPECT THIS PRODUCT BEFORE EACH USE. TIGHTLY SECURE CONNECTIONS AND REPLACE DAMAGED OR WORN COMPONENTS. CONTACT THE STEP2 COMPANY FOR REPLACEMENT PARTS.