JURA X10c Technical Documentation

Installation Site Requirements

• A level, water-resistant surface.
• Environmental conditions:
  • Max. humidity 80 %
  • Ambient temperature 10–35 °C

Note: Connections required at the installation site must be carried out by a qualified professional before JURA service technicians can commission the appliance on your premises.

Note: Ensure that the connections at the installation site are as close as possible to the appliance's installation location (see connection hose lengths).

The instructions in the operating manual for your fully automatic coffee machine must be followed without fail (chapter "Installing the Appliance").

Dimensions

Diagram showing the front and side views of the JURA X10c with key dimensions:

• Front view width: 373 mm
• Side view width: 464 mm
• Height: 470 mm
• Depth of drip tray area: 201 mm
• Height to drip tray: 119.6 mm
• Height to water connection: 63-150 mm
• Height to waste water connection: 58.4 mm

Overview: Site Requirements and Installation Instructions

Diagram illustrating the installation setup for the X10c with a fixed water connection according to DVGW W540:

• Power Connection: Required at the installation site.
• Water Connection: Requires a shut-off valve and a fine filter. The connection should be open and pressureless, with a metal hose (1.5 m) connecting to the appliance.
• Waste Water Connection: Requires a waste water hose leading to a drain with a water trap. The connection between the waste water hose and the drain pipe should be open and pressureless.

Note: An installation guide for the fixed water connection can be found on the JURA website.

QR code linking to jura.com/support-X10c

Appliance Rear View

Diagram showing the rear of the JURA X10c with connection points:

• 1. Drip water hose connection: G3/8" (plastic)
• 3. Water connection: G3/8" (plastic)
• Dimensions indicated: 18 mm, 76 mm, 22 mm, 84 mm, 204 mm, 243 mm.

Placement of Hole in Worktop for Coffee Grounds Ejector

Diagram showing the placement of the hole in the worktop for the coffee grounds ejector:

• 2. Placement of pipe fitting for coffee grounds ejector.
• Hole diameter: minimum 70 mm.
• Dimensions indicated: 193 mm, 180 mm, 201 mm, 235 mm, 220 mm.