JURA X10c (EA/SA/INTA)

Requirements for installation location

• Horizontal surface that is not sensitive to water
• Ambient conditions:
  • Air humidity max. 80%
  • Ambient temperature 10–35°C

i The required connections at the customer's premises must be carried out by an approved qualified person before the JURA service technician can set up the machine at your chosen location.

i Please make sure that the building connections are as close as possible to the location of the machine (refer to length of connection pipes).

Always note the information in the instructions for use for your coffee machine (Chapter “Setting up the machine”).

JURA Elektroapparate AG, Kaffeeweltstraße 10, CH-4626 Niederbuchsiten, jura.com

Dimensions

Diagram showing the dimensions of the JURA X10c coffee machine. Key dimensions include:

• Width: 373 mm
• Height: 470 mm
• Depth: 464 mm
• Additional depth with door open: 201 mm
• Height clearance for drip tray removal: 58.4 mm
• Height clearance for water tank removal: 119.6 mm
• Height clearance for bean hopper access: 63-150 mm

Overview: On-site requirements and installation instructions

Diagram illustrating the water connection and drainage for the JURA X10c (Mains water version in accordance with DVGW W540).

• Mains connection: Requires a shut-off valve and a fine filter on site.
• Drain connection: Requires an open, unpressurised connection between the residual water hose and the waste water pipe, including a drain siphon.
• Hoses: Includes a metal hose (1.5 m) and a residual water hose.

i You can find an installation guideline for the permanent water connection on our website: jura.com/support-X10c

Back of the machine

Diagram showing the connections on the back of the JURA X10c:

• G3/8" (plastic) connection for water.
• Dimensions indicating spacing for connections: 22 mm, 84 mm, 204 mm, 243 mm.
• Labels indicate: 1 Position of drain hose, 3 Position of permanent water connection.

Position of hole in work surface for coffee grounds disposal

Diagram illustrating the placement and size of the hole required in the work surface for coffee grounds disposal.

• Dimensions for hole placement: 193 mm, 180 mm.
• 2 Position of tube section for coffee grounds disposal.
• Hole diameter: min. 70 mm.