JURA X10c Technical Documentation

Installation Site Requirements

• Horizontal and water-resistant surface
• Environmental Conditions:
  • Max. air humidity: 80%
  • Ambient temperature: 10–35 °C

Note: Necessary connections must be made by a certified technician before the JURA service technician can commission the appliance. Ensure connections are as close as possible to the installation site (refer to connection tube length). Unconditionally observe the instructions in the operating manual of your automatic coffee machine (chapter "Install the appliance").

Dimensions

Diagram showing front and side views with dimensions:

• Front View:
  • Width: 373 mm
  • Height: 470 mm
• Side View:
  • Width: 201 mm
  • Height: 464 mm
  • Depth (including drip tray): 58.4 mm (front to drip tray edge), 119.6 mm (total depth including drip tray), 63-150 mm (adjustable height for drip tray)

Overview: Site Requirements and Installation Instructions

Diagram illustrating a fixed water connection for the X10c according to DVGW W540:

• Water Supply:
• Shut-off valve
• Fine filter
• Note: Customer side
• Waste Water Connection:
• Metal hose (1.5 m)
• Open and pressureless connection between the waste water hose and the drain pipe
• Outlet with siphon
• Note: Customer side

Note: A detailed installation guide for the fixed water connection is available on the JURA website (jura.com/support-X10c).

Appliance Rear View

Diagram showing the rear of the appliance with connection points:

• G3/8" (plastic) connection for water supply
• Note:
  1. Location of the waste water pipe
  2. Location of the fixed water connection

Location of the Knock-out Hole for Coffee Grounds on the Worktop

Diagram showing the placement and dimensions for the coffee grounds disposal hole:

• Dimensions indicating distances for placement: 193 mm, 180 mm, 204 mm, 243 mm
• Note: Location of the tube section for coffee grounds disposal
• Hole diameter: min. 70 mm