JURA X10c Technical Documentation
Product Identification
Model: X10c (EA/SA/INTA)
Installation Location Requirements
The following conditions must be met for the installation location:
- Horizontal surface, water-resistant.
- Environmental conditions:
- Air humidity: maximum 80%
- Ambient temperature: 10–35 °C
Important Notes:
Any necessary local connections must be prepared by an authorized expert before the JURA service technician can commission the appliance on-site.
Ensure that local connections are located as close as possible to the appliance's installation location (refer to the length of the flexible hoses).
Absolutely observe the warnings in the operating instructions for the automatic specialty coffee machine (chapter "Appliance Location").
Dimensions
Diagrams showing the dimensions of the JURA X10c are provided. Key dimensions include:
- Width: 373 mm
- Depth: 464 mm
- Height: 470 mm
- Water connection height: 63-150 mm
- Residual water hose connection height: 119.6 mm
- Fixed water connection height: 58.4 mm
Overview of Requirements and On-Site Installation Instructions
This section details the requirements for a fixed water connection according to DVGW W540.
Water Supply Connection:
- Connection to the mains water supply.
- Stopcock required.
- Fine filter required.
- Flexible metal hose (1.5 m) for water supply.
Residual Water Connection:
- Residual water hose.
- Open and unpressurized connection between the residual water hose and the wastewater pipe.
- Wastewater drain with a siphon.
Important:
- Connections must be prepared on-site.
- A guide for the installation of the fixed water connection is available on the JURA website.
Rear View of the Appliance
The rear of the appliance shows connection points:
- G3/8" (plastic) connection for water supply.
- Position of the residual water hose.
- Position of the fixed water connection.
Worktop Hole Position for Coffee Ground Expulsion
Details the required hole in the worktop for expelling coffee grounds:
- Position of the hose for coffee ground expulsion.
- Minimum hole diameter: 70 mm.
Contact Information
JURA Elektroapparate AG, Kaffeeweltstraße 10, CH-4626 Niederbuchsiten, jura.com
