JURA X10c (EA/SA/INTA)
Technical Documentation
Requirements for Installation Location
- Horizontal surface that is not sensitive to water
- Ambient conditions:
- Air humidity max. 80%
- Ambient temperature 10–35°C
[Information] The required connections at the customer's premises must be carried out by an approved qualified person before the JURA service technician can set up the machine at your chosen location.
[Information] Please make sure that the building connections are as close as possible to the location of the machine (refer to length of connection pipes).
Always note the information in the instructions for use for your coffee machine (Chapter “Setting up the machine”).
Dimensions
Machine Dimensions
Diagrams showing the JURA X10c machine dimensions:
Front View:
Width: 373 mm, Height: 470 mm, Depth: 464 mm.
Side View:
Height: 470 mm, Depth: 464 mm. Key vertical measurements from the base/bottom edge: 58.4 mm, 119.6 mm, and a range of 63-150 mm. A measurement of 201 mm is also indicated.
Top View:
Width: 373 mm, Depth: 464 mm.
Overview: On-site Requirements and Installation Instructions
Mains Water Version (X10c: Mains water version in accordance with DVGW W540)
Diagram illustrating water and drain connections:
Water Supply:
- Mains connection: Requires a shut-off valve on site.
- A fine filter is recommended on site.
- Connection is via a metal hose (1.5 m).
Wastewater Disposal:
- Residual water hose: Connects to a drain/siphon.
- Requires an open, unpressurised connection between the residual water hose and the waste water pipe.
- Drain connection is on site.
[Information] You can find an installation guideline for the permanent water connection on the JURA website.
Back of the Machine
Connections on the Back
Diagram showing the rear view of the machine with connection points:
- Connection 1: Position of drain hose.
- Connection 3: Position of permanent water connection (G3/8" plastic).
Various dimension lines are present, indicating distances between connection points and edges (e.g., 22 mm, 84 mm, 204 mm, 243 mm).
Position of Hole in Work Surface for Coffee Grounds Disposal
Coffee Grounds Disposal Hole
Diagram indicating the required hole in the work surface for coffee grounds disposal:
- Position 2: Marks the tube section for coffee grounds disposal.
- Hole diameter: Must be a minimum of 70 mm.
Dimensions like 193 mm and 180 mm are shown relative to the placement of this hole.
JURA Coffee Machines: Latte Macchiato, Cappuccino, Espresso and Coffee - JURA
JURA Coffee Machines: Latte Macchiato, Cappuccino, Espresso and Coffee - JURA
