Important Safety and Installation Instructions
CAUTION:
Before starting, turn off power at the main circuit panel.
Important Safety Instructions
- For indoor use only.
- Regularly check the cord, the transformer, and all other parts for damage. If any part is damaged, the product should not be used.
- Keep these instructions for future use.
Product Specifics
CAUTION!
- The light source of this product is non-changeable light diodes (LED).
- Do not disassemble the product, as the light diodes can cause damage to the eyes.
- Do not immerse in water.
Cleaning
Use a damp cloth; never use a strong cleaning agent.
WARNING:
Deviation from the assembly instructions may result in a risk of fire or electric shock.
FCC Compliance Information
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SAVE THESE INSTRUCTIONS
Assembly Steps
Tools Required: Phillips head screwdriver, flathead screwdriver, spirit level, utility knife, scissors.
Components: Three pendant shades, suspension wires, main housing/driver box, ceiling mount plate, main bar, power cord, screws, and fixings.
Step 1: Prepare the Main Housing
Open the main housing/driver box. Connect the internal wires: Live (Phase/Con corriente), Neutral (Neutre/Neutro), and Earth/Ground (Terre/Tierra) to the corresponding terminals within the housing. Ensure correct wire identification and secure connections. Close and secure the housing.
Step 2: Mount the Ceiling Canopy
Attach the ceiling mount plate to the ceiling using appropriate fixings. Use a spirit level to ensure it is horizontal. Feed the suspension wires through the designated openings in the canopy.
Step 3: Prepare the Main Bar
Attach the main bar to the suspension wires. The bar may be 50 cm (20") or 100 cm (40") in length depending on the specific configuration. Secure the wires to the bar at the designated points.
Step 4: Insert and Secure Pendant Shades
Insert each of the three pendant shades onto the main bar. Align the shades with the mounting points on the bar. Secure each shade in place, typically using two small screws per shade. Ensure the shades are oriented correctly.
Step 5: Attach Housing to Canopy
Connect the main housing/driver box to the mounted ceiling canopy. Align the housing with the canopy and secure it using the provided screws.
Step 6: Connect Power
Connect the main power cord to the housing. Ensure it is plugged in securely; an audible "click" may indicate a proper connection.
Step 7: Final Adjustments
Adjust the height and position of the shades and the main bar as desired. Ensure all components are firmly attached and the lamp is securely installed.
