SAMBORD Pendant Lamp

Important Safety Information

CAUTION: Before starting installation, turn off power at the main circuit panel. (Also noted in French: ATTENTION: Coupez l'alimentation avant de procéder à l'installation. and Spanish: ADVERTENCIA: Antes de comenzar el montaje, cortar la luz en el cuadro general.)

Tools and Components

Required Tools:

• Screwdriver (Phillips head) [?]
• Screwdriver (Flathead) [?]
• Pencil [✏️]
• Scissors [✂️]

Product Components:

• 1x Ceiling mounting plate with suspension hook and wiring
• 3x Lampshades with suspension wires and bulb sockets

Refer to IKEA for specific part numbers or additional components.

Installation Steps

Step 1: Prepare the Main Bar

Attach the end caps or connectors (2x) to the main bar. The diagram shows these being screwed into place using a screwdriver.

Step 2: Prepare Mounting Bracket

Cut a mounting bracket or support piece to a length of 920 mm (approximately 36.2 inches). The diagram shows a piece being cut with scissors.

Step 3: Secure Ceiling Mount

Attach the ceiling mounting plate to the ceiling using appropriate fixings. The diagram shows two screws securing the plate, indicating it's mounted to a surface.

Step 4: Mount Main Bar

Connect the main bar assembly to the ceiling mounting plate. The diagram shows the bar being lifted [⬆️] and attached to the plate, likely via the suspension hook.

Step 5 & 6: Initial Wiring Setup

The diagrams illustrate the initial routing of the suspension wires and the main power cable through the ceiling canopy, preparing for electrical connections.

Step 7: Identify Wires

Understand the wire connections:

• Live/Phase/Con corriente: Typically black or brown wire.
• Neutral/Neutre/Neutro: Typically blue or white wire.
• Earth/Terre/Tierra: Typically green/yellow or bare wire.

Step 8 & 9: Connect Wiring

Connect the wires from the ceiling to the corresponding wires on the fixture. The diagrams show the wires being fed through a connector block and secured, with a circular arrow indicating a connection or securing action.

Step 10: Attach Lampshades

Carefully attach each lampshade to its socket on the main bar. Ensure they are properly seated. CAUTION: Do not overtighten.

Step 11: Secure Suspension Cables

Use the provided clips (2x) to secure the suspension cables neatly along the main bar or to the ceiling mount, as shown in the diagram.

Step 12: Install Light Bulbs

Install the light bulbs into the sockets. IMPORTANT: Use only GU10 LED bulbs. Do not use GU10 Halogen bulbs.

Step 13: Final Check

Ensure the lampshades are correctly oriented and securely attached. The diagram shows a correct installation (left) and an incorrect one (right, marked with a cross [❌]).