T3073BU-BK-C Assembly Instructions

Assembly Steps

1. Step 1: Mark the mounting holes on the wall according to the hole spacing of the mounting plate. Drill holes on the wall (Refer to Diagram A for wall preparation).
2. Step 2: Gently tap the plastic drywall anchors (B) into the drilled holes using a hammer.
3. Step 3: Install the mounting plate (C) onto the wall using the provided screws (D).
4. Step 4: Wrap a few loops of the ground wire (E) around the green screw on the mounting plate (C) and then tighten the green screw securely.
5. Step 5: Attach the canopy (F) to the mounting plate (C) using the ball nuts (G).
6. Step 6: Place the lamp shade (H) around the lamp holder and secure it using the socket ring (J).
7. Step 7: Screw the light bulb (K, ST64 type) into the lamp holder. (Note: Bulb is not included).

Important Safety Note: Please consult a qualified Electrician if you are not familiar with electrical wiring.

Diagram Descriptions

The following describes the components and diagrams shown:

Wall Mounting and Parts Identification

This section illustrates the installation process.

• A: Represents the wall surface where the fixture will be mounted.
• B: Depicts plastic drywall anchors and a hammer, indicating their use for securing the fixture to the wall.
• C: Shows the mounting plate that attaches to the wall.
• D: Illustrates the screws used to fasten the mounting plate to the wall.
• E: Represents the ground wire, typically green or bare copper.
• F: Shows the canopy, which covers the mounting hardware.
• G: Depicts ball nuts used to secure the canopy.

Bulb Information

• K (ST64): An illustration of a light bulb. The text "(Bulb not included)" indicates that the bulb must be purchased separately. The bulb type is specified as ST64.

Shade and Socket Ring

• H: Represents the lamp shade.
• J: Represents the socket ring used to hold the lamp shade in place.

Wiring Identification Guide

Instructions for differentiating the plug-in cord wires:

• Live Wire: Identified by "(L) Parameters Printed on Wire Cover".
• Neutral Wire: Identified by "Nothing Printed on Wire Cover".