HAGOR BrackIT® S-II Installation Guide
Art.-Nr.: 8427
Safety Information
Caution! Technical devices are of considerable value. Handle components carefully during installation and protect them if necessary. Secure the installation area. Falling parts can cause injuries and material damage. Check if included materials are suitable for the specific conditions at the installation site and replace them with suitable materials if necessary. If you are unsure about the installation of the product or have any questions, please contact HAGOR Products GmbH or other trained specialists.
Scope of Delivery
The following components are included:
- Component A: Wall mounting plate (1x)
- Component B: Screen mounting bracket (1x)
- Component C: Cover caps (2x)
Fasteners:
- a: M4x20 screws (4x)
- b: M6x25 screws (4x)
- c: M8x25 screws (4x)
- d: Ø8 washers (4x)
- e: M6 washers (7x)
- f: Ø10x61 dowels (3x)
- g: St6x70 screws (3x)
- h: M6x8 screw (1x)
Tools required:
- [Screwdriver]
- [Wrench]
- [Spirit Level]
- [Drill]
Installation Steps
1a. Mounting to Wood Stud Wall
Description: This step details mounting the bracket to a wood stud wall. It involves drilling pilot holes (5mm diameter) into the wood stud to a depth of 50mm. Component A (wall plate) is then attached to the wall using screws (g) and washers (e). A spirit level should be used to ensure the plate is mounted horizontally.
Instruction: Check the suitability of the wall before installation!
1b. Mounting to Brick or Concrete Wall
Description: This step details mounting the bracket to a brick or concrete wall. It involves drilling holes (10mm diameter) to a depth of 70mm. Dowels (f) are inserted into these holes. Component A (wall plate) is then attached to the wall using screws (g) and washers (e). A spirit level should be used to ensure the plate is mounted horizontally.
Instruction: Check the suitability of the wall before installation!
2a. Mounting Screen (Flat Back)
Description: This step shows how to attach Component B (screen bracket) to the back of a flat-screen television. Screws (a/b/c) and washers (d) are used to secure Component B to the TV's VESA mounting points.
2b. Mounting Screen (Arched Back)
Description: This step shows how to attach Component B (screen bracket) to the back of a television with an arched back. Screws (a/b/c) and washers (d) are used to secure Component B to the TV's VESA mounting points.
3. Hang up and Secure the Screen
Description: The television, with Component B attached, is hung onto Component A (wall plate). The screen is then secured in place using screw (h). The diagram also illustrates adjusting the tilt angle of the screen.
4. Make Settings
Description: This step involves adjusting the mobility and inclination of the mounted screen. The diagrams show how to adjust the hinge mobility and the tilt inclination using adjustment points on the bracket.
Adjustments:
- Adjust hinge mobility
- Adjust inclination
5. Mounting Covers / Cable Management
Description: Component C (cover caps) are attached to conceal mounting points or to help manage cables for a cleaner look.
Dimensions and Specifications
The dimensions of the HAGOR BrackIT® S-II mount are as follows:
| Width: | 64 - 342 mm |
| Height: | 200 mm |
| Depth (from wall): | 223 mm |
| Tilt Angle: | -5° / +12° |
| Maximum Load Capacity: | 25 kg |
