HAGOR BrackIT® XS-I TV Wall Mount Installation Guide
Model: BrackIT® XS-I | Article No.: 8424
Important Safety Information
❗ Caution!
Technical devices are of considerable value. Handle components carefully during installation and protect them if necessary.
If necessary, the installation area should be secured. Falling parts can cause injuries and material damage.
The materials included in the scope of delivery may not be suitable for the special conditions at the installation site. Please check this in advance and replace them with suitable materials if necessary.
If you are unsure about the installation of the product or have any questions, please contact HAGOR Products GmbH or other trained specialists.
Scope of Delivery
The following parts and hardware are included:
- A: Wall mounting bracket (1x)
- B: VESA mounting plate (1x)
Hardware:
- a: 4x M4x20 screws
- b: 4x M6x25 screws
- c: 4x Ø12 washers
- d: 7x M6 washers
- e: 3x Ø10x61 wall anchors
- f: 3x St6x70 screws
- g: 1x M6 nut
- h: 2x M6x8 screws
Required Tools (not included):
- Screwdriver (Phillips head) ?
- Wrench ?
- Drill [drill]
- Hammer [hammer]
Installation Steps
Step 1: Mounting the Bracket to the Wall
1a: Mounting to a Wood Stud Wall
Attach the wall mounting bracket (A) to a wood stud wall. Use screws (f) and washers (d) as shown in the diagram. Ensure the wall is suitable before installation.
1b: Mounting to a Brick or Concrete Wall
Attach the wall mounting bracket (A) to a brick or concrete wall. Use wall anchors (e) and screws (f) as shown in the diagram. Ensure the wall is suitable before installation.
❗ Check the suitability of the wall before installation!
Step 2: Mounting the VESA Plate to the Screen
2a: For Screens with a Flat Back
Attach the VESA mounting plate (B) to the back of a flat-screen TV or monitor. Use screws (a or b) with appropriate washers (c or d) as indicated. Ensure a gap of approximately 3mm is maintained if needed.
2b: For Screens with an Arched Back
Attach the VESA mounting plate (B) to the back of an arched-screen TV or monitor. Use screws (a or b) with appropriate washers (c or d) as indicated. Ensure a gap of approximately 3mm is maintained.
Step 3: Hanging and Securing the Screen
Hang the screen, with the VESA plate attached, onto the wall mounting bracket (A). Secure the screen using screws (g) and (h) as shown.
Step 4: Making Adjustments
Adjust Hinge Mobility: Use the designated points on the arm joints to adjust the movement range of the bracket.
Adjust Inclination: Adjust the tilt angle of the screen as desired. The bracket supports a tilt range of -5° to +12°.
Step 5: Mounting Covers and Cable Management
Attach the decorative covers (C and D) to the bracket. Route cables neatly through the designated channels for cable management.
