JABLOTRON JA-110N-DIN Bus Power Module
DIN Rail Guide
This document has been automatically translated from the original English. For any uncertainties or doubts, please refer to the original document version. If you encounter errors or have further questions, please contact technical support (contact details are at the end of this document).
The product is a component of the JABLOTRON system. It provides a power relay with a PG output. The relay can be used to control lighting, fans, etc. The module must be installed by a qualified technician with a valid certificate issued by an authorized distributor.
Installation
Electrical devices may only be connected by a qualified technician.
When connecting the module to the system bus, always switch off the power supply.
- Install the module on the DIN rail.
- Connect the bus cable to the terminals (1).
- Verify the module's operation by pressing the button (4). When the module is powered on, the red RELAY LED (2) lights up.
- Connect the controlled device to the output terminals (5).
Note: If communication is lost, the yellow STATUS LED (3) indicates this condition, and after 60 seconds, the relay switches to the resting state.
Figure 1: Description of the product's external parts
- 1 - bus terminals
- 2 – trigger LED indicator
- 3 – fault LED indicator
- 4 – learning/manual trigger button
- 5 – relay terminals
System Enrollment and Settings
Depending on the control panel type, use the recommended software or application; consult the control panel manual.
Technical Specifications
| Parameter | Value |
|---|---|
| Power source | From the control panel bus 12 V (9–15 V) |
| Current consumption at rest (relay OFF) | 5 mA |
| Maximum current consumption (relay ON) | 45 mA |
| Relay contact load: (galvanically separated and safe from the bus) | |
| Maximum switched voltage | 250 V AC / 24 V DC |
| Resistive load (cos φ = 1) | max. 16 A |
| Inductive, capacitive load (cos φ = 0.3) | max. 6 A |
| Halogen lighting | max. 1000 W |
| DC continuous current | 384 Ω |
| Minimum switched DC output | 0.5 W |
| Power dissipation | 1.6 W |
| Current interruption for electric panel heating | 1.9 W |
| Connected wire diameter | max. 2 x 1.5 mm²; 1 x 2.5 mm² |
| Environment | indoor general use |
| Operating temperature range | -10 °C to +40 °C |
| Average operating humidity | 75% RH, non-condensing |
| Dimensions | 18 x 90 x 64 mm (according to EN 60715) |
| Weight | 65 grams |
| Certification body | Trezor Test s.r.o. (No. 3025) |
| Complies with | EN 50130-4, EN 55032, EN IEC 62368-1, EN IEC 63000 |
Compliance and Disposal
CE UKCA
JABLOTRON a.s. hereby declares that the JA-110N-DIN product complies with the relevant EU harmonization legislation: Directives No.: 2014/35/EU, 2014/30/EU, 2011/65/EU, when used as intended. The original declaration of conformity is available at http://www.jablotron.com, Downloads section.
Note: Proper disposal of this product will help conserve valuable resources and prevent potential negative effects on human health and the environment, which could otherwise result from improper waste disposal. Return the product to the retailer or contact the local authority for more information on the nearest designated collection point.
For an electronic version of this manual (available in other languages) or an installer version for JA-100+, scan the attached QR code.
