JABLOTRON JA-110N-DIN Bus Power Output PG-Module
Installation and Technical Specifications
Introduction
This document provides information on the JABLOTRON JA-110N-DIN bus power output PG-module. This product is a component of the JABLOTRON system and features a PG output relay switch. The relay can be used for controlling lighting, fans, etc. The module must be installed by a trained technician holding a valid certificate from an authorized distributor.
Installation
[Warning] Electrical devices must only be connected by a trained technician.
Always switch off the power supply before connecting the module to the system bus.
- Install the module on the DIN-rail.
- Connect the bus cable to the terminals (1).
- Test the module's operation by pressing the button (4). When the module is powered on, the red RELAY LED (2) will light up.
- Connect the controlled device to the output terminals (5).
Note: If communication is lost, the yellow STATUS LED (3) will indicate this, and the relay will switch to its resting state after 60 seconds.
Figure 1: External Components Description
The module features the following external components:
- 1 – Bus terminals
- 2 – Trigger LED indicator
- 3 – Fault LED indicator
- 4 – Learn/manual trigger button
- 5 – Relay terminals
System Integration and Settings
Use the recommended software or application depending on the type of control panel. Refer to the control panel's manual for guidance.
Technical Specifications
| Parameter | Specification |
|---|---|
| Power | From the control panel bus 12 V (9-15 V) |
| Standby current consumption (relay OFF) | 5 mA |
| Maximum current consumption (relay ON) | 45 mA |
| Relay contact load: (galvanically and safely separated from the bus) | |
| - Maximum switched voltage | 250 V AC / 24 V DC |
| - Resistive load (cos φ = 1) | max. 16 A |
| - Inductive, capacitive load (cos φ = 0.3) | max. 6 A |
| - Halogen lighting | max. 1000 W |
| - DC current | 384 W |
| - Minimum DC switched output | 0.5 W |
| Power loss | 1.6 W |
| Power loss for heating control panels | 1.9 W |
| Diameter of connected wires | max. 2 x 1.5 mm²; 1 x 2.5 mm² |
| Environment | Indoor general |
| Operating temperature range | -10 °C to +40 °C |
| Average operating humidity | 75% RH, non-condensing |
| Dimensions | 18 x 90 x 64 mm (according to EN 60715) |
| Weight | 65 grams |
| Certification Body | Trezor Test sro (No. 3025) |
| Conforms to | EN 50130-4, EN 55032, EN IEC 62368-1, EN IEC 63000 |
Compliance and Declarations
JABLOTRON a.s. hereby declares that the product JA-110N-DIN complies with the relevant Union harmonisation legislation: Directives No. 2014/35/EU, 2014/30/EU, 2011/65/EU, when used as intended. The original of the conformity assessment can be found at http://www.jablotron.com, Downloads section.
The product bears CE and UK CA marks.
Disposal Information
By disposing of this product correctly, you save valuable resources and prevent potential negative effects on human health and the environment that might otherwise arise from improper waste handling. Please return the product to your dealer or contact your local municipality for more information on the nearest collection point.
Company Information
JABLOTRON a.s.
Pod Skalkou 4567/33
46601 Jablonec nad Nisou
Czech Republic
Tel.: +420 483 559 911
Internet: www.jablotron.com
