JABLOTRON JA-110N-DIN Bus Power Supply PG Module – DIN-rail
This document is machine-translated from the original English version. In case of uncertainty or doubt, please refer to the original version of the document. If you encounter errors or have further questions, please contact technical support (contact information is at the end of this document).
The product is part of the JABLOTRON system. It features a PG output relay contact. The relay can be used to control lighting, ventilation, etc. The module must be installed by a trained technician with a valid certificate issued by an authorized distributor.
Installation
⚠️ Electrical equipment must only be connected by a trained technician.
Always switch off the power when connecting the module to the system bus.
- Install the module on the DIN-rail.
- Connect the bus cable to the terminals (1).
- Test the module's function by pressing the button (4). When the module is powered on, the red RELAY LED (2) will light up.
- Connect the controlled device to the output terminals (5).
Note: If communication is lost, the yellow STATUS LED (3) indicates this condition, and after 60 seconds, the relay will switch to an inactive state.
Figure 1: Description of the product's external parts
1 – bus terminals; 2 – LED indicator for trigger; 3 – LED indicator for fault; 4 – button for learning/manual trigger; 5 – relay terminals.
System Registration and Settings
Depending on the type of control panel, use the recommended software or application. Refer to the control panel's manual.
Technical Specifications
| Parameter | Value |
|---|---|
| Power | from the central unit bus 12 V (9-15 V) |
| Quiescent current (relay OFF) | 5 mA |
| Maximum current consumption (relay ON) | 45 mA |
| Relay contact load: (galvanically and safely isolated from the bus) | |
| Maximum switching voltage | 250 V AC / 24 V DC |
| Ohmic load (cos φ = 1) | max. 16 A |
| Inductive, capacitive load (cos φ = 0.3) | max. 6 A |
| Halogen lighting | max. 1000 W |
| Direct current | 384 W |
| Minimum DC coupled output | 0.5 W |
| Power loss | 1.6 W |
| Power consumption for heating the control panel | 1.9 W |
| Diameter of connected wires | max. 2 x 1.5 mm² / 1 x 2.5 mm² |
| Environment | indoor general use |
| Operating temperature range | -10 °C to +40 °C |
| Average operating humidity | 75% RH, non-condensing |
| Dimension | 18 x 90 x 64 mm (according to EN 60715) |
| Weight | 65 g |
| Certification body | Trezor Test s.r.o. (No. 3025) |
| Complies with | EN 50130-4, EN 55032, EN IEC 62368-1, EN IEC 63000 |
Compliance and Declaration
CE marking, UKCA marking
JABLOTRON a.s. hereby declares that the JA-110N-DIN product is in compliance with the relevant EU harmonisation legislation: Directive No.: 2014/35/EU, 2014/30/EU, 2011/65/EU, when used as intended. The original of the conformity assessment can be found at www.jablotron.com/downloads.
Disposal Notice
Note: Correct disposal of this product will help conserve valuable resources and prevent potential negative impacts on human health and the environment, which could otherwise arise from inappropriate waste handling. Please return the product to the dealer, or contact your local municipality for further information on the nearest collection point.
Contact Information
JABLOTRON a.s.
Pod Skalkou 4567/33
46601 Jablonec nad Nisou
Czech Republic
Tel.: +420 483 559 911
Internet: www.jablotron.com
