Yaheetech 593027/593028 Assembly Instructions

Important Safety Information

Please read all instructions carefully before beginning assembly.

⚠️ Warning: Keep small parts away from children. Ensure all hardware is tightened securely. Do not overtighten screws.

? Note: Two people may be required for certain assembly steps. Assemble on a soft, clean surface to prevent scratches.

Package Contents

Verify that all parts and hardware are present before assembly. Refer to the included parts list diagram (described below).

• Main Panels (e.g., Side Panels A, Top Panel B, Bottom Panel C)
• Shelves (e.g., Shelf D, Shelf E)
• Backing Board (F)
• Hardware Pack (containing screws, dowels, cam locks, Allen key, etc.)
• Instruction Manual (this document)

The parts list typically shows each component labeled with a letter or number. For example, Panel A might be a large rectangular piece, Panel B a slightly smaller rectangular piece, and Shelf D a flat board. The hardware pack would contain various types of fasteners, such as wood screws, metal bolts, plastic dowels, and cam lock mechanisms, along with a small L-shaped tool (Allen key) for tightening bolts.

Tools Required (Not Included)

You may need the following tools for assembly:

• Phillips head screwdriver ?
• Hammer (for gently tapping dowels, if applicable) ?

Assembly Steps

Follow these steps carefully to assemble your product.

1. Step 1: Attach Side Panels to Base

   Take the Bottom Panel (C) and insert wooden dowels into the pre-drilled holes. Attach the Side Panels (A) to the Bottom Panel (C) by aligning the dowels and securing with screws or cam locks as indicated. Ensure the panels are flush.

   ? Tip: Use the provided Allen key to tighten cam locks.

2. Step 2: Install Shelves

   Insert shelf support pins into the desired height holes on the inside of the Side Panels (A). Place the Shelves (D, E) onto the support pins. Ensure shelves are level.

   ⚠️ Caution: Do not force shelves into place.

3. Step 3: Attach Top Panel

   Place the Top Panel (B) onto the assembled structure, aligning it with the Side Panels (A) and any connecting dowels or screws. Secure the Top Panel firmly.

   ✔️ Check: Ensure the unit is stable.

4. Step 4: Install Backing Board

   Carefully slide the Backing Board (F) into the grooves on the back of the unit. If it's a nail-on type, use the provided small nails to secure it evenly around the perimeter.

   ? Note: The backing board adds structural integrity.

5. Step 5: Final Tightening and Placement

   Go back and ensure all screws and fasteners are securely tightened. Place the assembled unit in its desired location.

   ⚠️ Important: If the unit is tall or intended to hold heavy items, consider using the included anti-tip hardware to secure it to a wall.

Care and Maintenance

To keep your Yaheetech product looking its best:

• Clean with a soft, damp cloth. Avoid abrasive cleaners.
• Wipe up spills immediately.
• Periodically check and retighten hardware if necessary.

Support

For missing parts, assembly assistance, or any other queries, please refer to the contact information provided on the original packaging or visit the Yaheetech website.