Installation & Assembly
Notice
1. Follow the installation instructions. Please confirm all accessories are preset before installation.
2. Do not fully tighten the screws during initial assembly. Fully tighten screws only once all pieces which are correctly assembled.
3. If you encounter any problems during installation, please contact customer service.
4. Please unbox the item from the side with an open label and place it on a carpeted floor to avoid scratching.
Recommended installers: 2 ???
Place a carpet on the floor before unpacking ?️
Estimated installation time: 20 ⏱️
Parts List
| Item no. | Reference Image | Qty |
|---|---|---|
| A | A flat, circular disc. | x1 |
| B | A circular disc with holes around the edge. | x1 |
| C | A cylindrical piece with a flat top and bottom. | x1 |
| 1 | A screw. | x8 |
| 2 | An L-shaped tool (Allen key). | x1 |
Assembly Steps
Step 1
Place part B onto part C. Insert eight screws (1) through the holes in part B and into part C. Use the Allen key (2) to tighten the screws, but do not fully tighten them yet.
Step 2
Place part A onto the assembled parts B and C. Insert eight screws (1) through the holes in part A and into part B. Use the Allen key (2) to tighten these screws. Once all parts are correctly assembled, fully tighten all previously installed screws.
