JURA X10c Technical Documentation
Model: X10c (EA/SA/INTA)
Installation Location Requirements
Placement Requirements:
- Horizontal and water-resistant surface.
Environmental Conditions:
- Air humidity: maximum 80%.
- Ambient temperature: 10–35 °C.
Important Notes for Installation:
i A qualified, authorized JURA service technician must install the necessary connections before the JURA service technician can commission the machine correctly on-site.
i Ensure that the customer's connections are as close as possible to the machine's installation location (refer to the length of the connection hoses).
Mandatory: Observe the instructions in your coffee machine's operating manual (chapter "Installing the machine").
JURA Elektroapparate AG, Kaffeeweltstraße 10, CH-4626 Niederbuchsiten, jura.com
Dimensions
Diagrams showing the dimensions of the JURA X10c machine.
Diagram 1: Front View Dimensions
Width: 373 mm
Height: 470 mm
Depth: 464 mm
Diagram 2: Side View Dimensions
Height: 470 mm
Width: 201 mm
Depth: 464 mm
Additional dimensions provided in the side view include 58.4 mm, 119.6 mm, and a range of 63-150 mm.
General Overview: Customer Requirements and Installation Instructions
X10c: Design for fixed water connection according to DVGW W540
Customer-Provided Connections:
- Water Connection:
- Shut-off valve.
- Fine filter.
- Flexible metal hose (1.5 m).
- Flexible water supply hose.
Waste Water Disposal:
- Open and unpressurized connection between the waste water hose and the wastewater pipe.
- Drain, siphoned.
i You will find an installation guide for the fixed water connection on our website: jura.com/support-X10c
Rear of the Machine
Diagram showing the rear of the machine with connection points.
G3/8" (plastic) connection
Key:
- Position of the drip tray.
- Position of the fixed water connection.
Dimensions indicated: 18 mm, 76 mm, 22 mm, 84 mm, 204 mm, 243 mm.
Drilling Position on the Work Surface for Automatic Grounds Expulsion
Diagram illustrating the drilling position for the automatic grounds expulsion tube.
Position of the tube for automatic grounds expulsion.
Drilling position: minimum diameter 70 mm.
Dimensions indicated: 193 mm, 180 mm, 70 mm, 263 mm, 201 mm.
