Replacing the Remote Control

To ensure that Human Touch products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these product repair instructions.

Tools and Notes

Tools Required: Phillips-head screwdriver

NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.

Removing the Remote Control

1. Power off the chair and unplug it.
2. Locate the remote control bracket on the back of the backrest (Fig.1).
3. Using a Phillips-head screwdriver, remove the two screws that secure the remote control bracket to the backrest cover.
4. Pull the remote control cables through the backrest cover, then disconnect the cables.

Figure 1 shows the back of the massage chair, highlighting the remote control bracket. A magnified view details the bracket secured by two screws to the backrest cover, with the remote control cable connected.

Installing the New Remote Control

1. Connect the new remote control cables to the backrest remote control cables, then push the cables into the backrest.
2. Using a Phillips-head screwdriver, replace the two remote control bracket screws.
3. Power on the chair and verify that the new remote control works.

Please send any questions or comments regarding these instructions to: documentation@humantouch.com

© 2008 Human Touch, LLC.